Advertisement
Quick Links
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according
to these instructions and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION
Air brush kit including the AB932 professional gun and a comprehensive set of accessories including knife set
and air brush holder. Supplied in carry-case. Ideal for the serious air brush artist, or professional artist.
CONTENTS: AB932 professional gun with one 22cc and one 60cc paint jar.
3. ASSEMBLY
Note: Numbers in brackets refer to item numbers on the parts
diagram.
3.1. Fit the jar cover with nozzle (23), or the paint cup (22) into
3.2. Screw one end of the air hose (26) onto the air hose
3.3. To use a propellant can (Sealey Part No: AB/P) a regulator
3.4. To use a compressor (Sealey Model No: AB900) use the air
AB932/K
Issue No: 2 - 09/04/08
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND
WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are
adhered to when using tools.
Ensure that the air brush and accessories are in a clean, sound condition and good working order. Take
action for immediate repair or replacement of damaged parts. Use recommended parts only. The use of
unauthorised parts may be dangerous and will invalidate the warranty.
Ensure the air brush supply hose is not tangled, twisted or pinched.
DO NOT use air brush or accessories if damaged.
DO NOT operate air brush under the influence of drugs, alcohol, intoxicating medication, or if fatigued.
DO NOT direct spray against yourself, other persons, animals or electrical equipment.
DO NOT use the air brush for a task it is not designed to perform.
Wear approved eye protection and a suitable respirator when painting. A full range of personal safety
equipment is available from your Sealey Dealer.
DO NOT allow smoking or open flame in the work area.
One 100cc container of cleaning fluid.
Air brush stand.
Four additional 22cc paint mixing/storage jars.
the frame (1) as shown in fig.1.
connection of the air brush and the other end onto the air
supply.
valve/cap (Sealey Part No: AB930/11) is required, see fig.1.
hose adaptor to connect the air hose to the compressor, as
shown in fig.1.
INSTRUCTIONS FOR:
AIR BRUSH KIT
AB932/K
MODEL:
Knife set.
Small pot of light grease.
Soft paint brush.
Fig.1.
Regulator valve/cap
Adaptor for compressor
AB932/K
Issue No: 2 - 09/04/08
Advertisement
Related Manuals for Sealey AB932/K
Summary of Contents for Sealey AB932/K
- Page 1 AB932/K MODEL: Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
- Page 2 5.3.5. Should the needle need to be replaced, unscrew the needle securing screw (12), withdraw the needle 4.3. After mixing and thinning the paint, as instructed by the paint manufacturer, fill the paint jar or paint cup and replace with a new one (Sealey Part No: AB932/13). just over half full. 5.4.