Removal - Toro Reelmaster 5500-D Service Manual
Hide thumbs
Also See for Reelmaster 5500-D:
- Operator's manual (52 pages) ,
- Operator's manual (44 pages)
Table of Contents
Advertisement
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Open engine hood.
3. Disconnect both battery cables at the battery (see
Battery Service in Chapter 5 - Electrical system).
4. Disconnect yoke flange from the lower fan belt pulley
(Fig. 25).
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns.
Ethylene-glycol antifreeze is poisonous. Dis-
pose of coolant properly, or store it in a properly
labeled container away from children and pets.
5. Drain radiator coolant from the radiator drain and en-
gine block pet cock (LH) into a suitable container (see
Radiator Removal). Disconnect all coolant hoses from
the water pump, radiator cap, and engine block.
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the exhaust system
to cool before working on or near the muffler.
6. Disconnect air filter hose from the engine.
7. Disconnect wires and/or electrical connections from
the following electrical components:
A. The oil low pressure switch, starter, and alterna-
tor (Fig 26). The temperature sender (Fig. 27).
B. Battery, frame, and wire harness ground to the
engine block and the ETR solenoid (Fig. 28).
C. High temperature shutdown switch (Fig. 29).
Glow plug bus (Fig. 30).
8. Disconnect fuel hose from the rear injector nozzle
(Fig. 30).
9. Disconnect throttle cable from the cable clamp and
swivel on the speed control lever. Disconnect fuel hoses
from the water/fuel separator at the injector and fuel
pumps. Disconnect fuel hose from the fuel tank at the
fuel pump (Fig. 31).
Reelmaster 5500-D
1. Lower fan belt pulley
2. Yoke flange
1. Oil low pressure switch
2. Alternator
1. Temperature sender
10.Remove four locknuts, cap screws, and flat washers
securing the fan shroud to the radiator (Fig. 32).
Note: Use a piece of heavy cardboard to protect the
radiator fins during engine removal and installation.
11. Make sure all cable ties securing the wiring harness,
fuel lines, or hydraulic hoses to the engine are removed.
12.Connect hoist or lift to the front and rear lift tabs.
Page 3 - 19
3
1
2
Figure 25
3. Yoke slip tube
2
1
Figure 26
3. Starter
1
Figure 27
Kubota Diesel Engine
3
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
