Cutting Unit Installation - Toro Reelmaster 5500-D Service Manual
Hide thumbs
Also See for Reelmaster 5500-D:
- Operator's manual (52 pages) ,
- Operator's manual (44 pages)
Table of Contents
Advertisement
Cutting Unit Installation
Cutting unit models 03860, 03861, and 03862 can be
installed at any of the five mounting locations on the trac-
tion unit. Figure 1 shows the orientation of the hydraulic
drive motor for each of the five locations. For any of the
locations requiring the motor to be mounted on the right
end of the cutting unit, install a counter weight on the left
end of the cutting unit. For the locations requiring the
motor to be mounted on the left end, install a counter
weight on the right end of the cutting unit.
Note: Counter weight mounting capscrews are
shipped installed on the right bearing housing of the cut-
ting units. The capscrews on left bearing housing are to
be used for securing the hydraulic motor.
1. Remove cutting units from cartons. Assemble and ad-
just per Cutting Unit Operator's Manual.
2. Remove protective plugs from each end of cutting
unit.
3. Lubricate and install a large O-ring into bearing hous-
ing groove on each end of cutting unit (Fig. 38 & 40).
Note: Lubricate internal splines of cutting unit reels
shafts with grease before installing cutting unit motors.
4. Install a counter weight onto appropriate end of each
cutting unit with capscrews provided (Fig. 38).
5. Thoroughly grease the cutting unit reel bearings prior
to installation on the traction unit. Grease should be evi-
dent at the inboard reel seals (see Lubrication in this
section of this manual).
6. Insert a thrust washer onto horizontal shaft of pivot
knuckle as shown (Fig. 39).
7. Insert the horizontal shaft of the pivot knuckle into the
mounting tube of the carrier frame.
8. Secure pivot knuckle to carrier frame with a thrust
washer, flat washer and a flange head capscrew.
9. Insert a thrust washer onto vertical shaft of pivot
knuckle.
10. Insert the vertical shaft of the pivot knuckle into lift
arm pivot hub (Fig. 39). Guide the pivot knuckle in place
between the two rubber centering bumpers in the under
side of the lift arm steering plate.
11. Insert the lynch pin into the cross hole on the pivot
knuckle shaft (Fig. 39).
Reelmaster 5500-D
Motor
Weight
#4
Motor
#2
2
1. Bearing housing
2. O-ring
5
3
2
4
1. Carrier frame
2. Pivot knuckle
3. Lift arm steering plate
Page 8 - 27
Weight
Motor Weight
#1
#5
Weight
Weight
Motor
#3
Figure 37
1
3
Figure 38
3. Counterweight
1
Figure 39
4. Lynch pin
5. Steering pin
Cutting Units
Motor
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
