Table of Contents
Advertisement
Cisco Webex DX70 and DX80
Introduction
Provisioning of product specific configurations from CUCM
Set up provisioning from CUCM
1. Sign in to CUCM, navigate to
Device >
Phone, and find your device.
2. Find the Product Specific Configuration
Layout section (see illustration).
3. Click the
Miscellaneous
category and find
the Configuration Control Mode setting.
Choose your preferred mode: Unified CM,
Endpoint, or Unified CM and Endpoint (see
the description on the previous page).
4. Click the
Pull xConfig. from Device
button if you want to load the current
configuration from the device.
5. Select a category and set a value for the
configurations you want to change.
6. Finally, click
Save
and
Apply
Config, just
like you do in earlier CUCM versions.
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration
Configuration
Peripherals
Maintenance
(page 2 of 2)
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
54
Administrator Guide
Device settings
Appendices
Pull configurations from the
device on-demand
Click this button to pull any data
configuration from the device on-
demand.
Settings marked with a hash, #
Settings that also were available in
Cisco UCM releases prior to 12.5(1)
SU1.
Settings or parameters
The settings that belong to the
selected category.
Categories
The device settings are grouped
in categories. These are the same
categories that you find in the web
interface of the device. They also
correspond to the API command path.
Miscellaneous is an exception to this
rule. In this category you find settings
that only can be set by CUCM. They
don't correspond to a local setting on
the device.
Advertisement
Chapters
Table of Contents
