Page 1
CONDITIONER Simple Dry contact PDRYCB100 LG Electronics Inc. EU Representative : LG Electronics European Shared Service Center B. V . Krijgsman 1, 1186 DM Amstelveen, The Netherlands Manufacturer: LG Electronics Inc. Changwon 2nd factory, 84, Wanam-ro, Seongsan-gu, Changwon-si, Gyeongsangnam-do, KOREA www.lg.com...
Safety Precautions Dry Contact Unit Installation Manual Safety Precautions TABLE OF CONTENTS To prevent injury to the user or other people and property damage, the following instructions must be followed. n Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness is classified by the following indications.
Safety Precautions Safety Precautions Do not install the product Do not install the unit in Do not put the product Do not spill water inside of If the product has been in- Children and elderly use the in the place where rain can humid locations.
Dry Contact Controller Connector LG Dry Contact is a solution for automatic control of air conditioning system at the owner’s behest. In simple words, it’s a switch which can be used to turn the unit On/Off after getting the signal from external sources like key-in lock, door or window switch etc specially used in Hotel rooms.
Part Description Installation Method Part Description Installation Method Installation PDRYCB100 (PCB + Case) 1) Loosen and remove two screws that secure the prod- uct. Front Case Rear Case 2) Position the rear case to the direction towards to the connector for convenient cable arrangement.
Page 6
CN-CC CN-CC 24 V~ - Connection of Dry contact & LG Central Controller in case of single constant models. 1. Install the product on flat surface and install anchoring screws at more than 2 places. Otherwise DRY CONTACT the central controller may not be anchored properly.
Page 7
CN-CC RLY1 RLY2 Dry contact Controller CN_DRY INPUT 24 V~ LG does not supply this section - To apply power source directly to external source CANCEL Button DRY CONTACT Operation Display CN-CC Error Check Display 1. To turn ON the unit directly from the external source...