Advertisement
96in Air Cool Z Master
Model No. 74090—Serial No. 400000000 and Up
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
Operator's Manual
Engine owner's manual
Registration card
Operator training material
Key
Register at www.Toro.com.
®
Professional Riding Mower
Qty.
–
Add fuel to the machine.
–
Check the engine-oil level.
–
Check the tire pressure.
–
Check the hydraulic-fluid level.
–
Check the deck-lift power unit fluid level.
–
Check the battery.
–
Check the wheel lug nut torque.
Raise the rollover protection system
–
(ROPS).
Check the machine before delivery to
–
the customer (All machines).
1
1
1
Delivering the machine to the customer.
1
2
Original Instructions (EN)
All Rights Reserved *3433-857* A
Printed in the USA
Form No. 3433-857 Rev A
Setup Instructions
Use
Advertisement
Table of Contents
Related Manuals for Toro Air Cool Z Master 74090
Summary of Contents for Toro Air Cool Z Master 74090
- Page 1 (All machines). Operator's Manual Engine owner's manual Registration card Delivering the machine to the customer. Operator training material © 2019—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3433-857* A 8111 Lyndale Avenue South Printed in the USA...
-
Page 2: Checking The Engine Oil Level
Adding Fuel to the Machine Checking the Hydraulic-Fluid Level No Parts Required No Parts Required Procedure Procedure Add fuel to the machine before starting it. Refer to your Operator’s Manual for the correct fuel and Park the machine on a level surface, disengage procedure. -
Page 3: Checking The Battery
(Figure • Keep sparks, flames, or cigarettes away from battery. Note: If needed, add Toro Premium Transmission/Hydraulic Tractor Fluid until the • Ventilate when charging or using battery in fluid level is slightly above the internal gear pump in an enclosed space. - Page 4 for the recommended time interval to bring the charge up to a full charge of 12.6 V or greater. Important: Ensure that the negative battery cable is disconnected and the battery Checking the Wheel Lug charger used for charging the battery should have an output of 16 V and 7 A or less Nut Torque to avoid damaging the battery (see the...
- Page 5 Raising the Rollover Protection System (ROPS) No Parts Required g008619 Figure 4 Procedure 1. Engaged position 2. Partially engaged—do Pull the knob and rotate 90° to the unlatched not operate the machine position (Figure with the roll back in this position.
- Page 6 Checking the Machine Before Delivery to the Customer (All Machines) No Parts Required Procedure Before delivering the machine to the customer, ensure that you perform or have performed the procedures listed in the following table and initial each when finished. Refer to the Operator's Manual for instructions on performing these procedures.
- Page 7 Delivering the Machine to the Customer Parts needed for this procedure: Operator's Manual Engine owner's manual Registration card Operator training material Procedure At delivery, fill in the model and serial number, complete the items listed in the following table, and initial each when finished.
- Page 8 Ensure that the customer receives the Operator's Manual, engine owner’s manual, Setup Instructions, and operator training material. Ensure that the customer knows the Parts Catalog is available at www.Toro.com. Assist the customer in loading the machine using a full-width trailer ramp.