Related Manuals for Kenwood KDC-BT41U
Summary of Contents for Kenwood KDC-BT41U
- Page 1 KDC-BT41U KDC-BT31U KDC-4751SD CD-RECEIVER INSTRUCTION MANUAL © 2010 Kenwood Corporation All Rights Reserved. B64-4799-10/01 (EW/E0/E2W/E20)
-
Page 2: Table Of Contents
CONTENTS Safety Maintenance Preparation How to attach/detach the faceplate How to reset your unit Remote controller Basic Operations Muting upon the reception of a phone call (KDC-4751SD only) Getting Started Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operations Listening to the Radio Adjust [SETTINGS] mode settings... -
Page 3: Safety
If you experience problems during installation, consult your Kenwood dealer. ■ When you purchase external components, check with your Kenwood dealer to make sure that they work with your model and in your area. Maintenance Cleaning the unit: Wipe off the dirt on the panel with a dry silicon or soft cloth. -
Page 4: Basic Operations
: Indicates that the Music Search mode is selected now. BT: Bluetooth cell-phone connection status. The illustration and button names used for explanation in this manual are of KDC-BT41U/ KDC-BT31U (unless mentioned otherwise). Refer to the table below for the difference: KDC-BT41U/ KDC-BT31U... -
Page 5: Muting Upon The Reception Of A Phone Call (Kdc-4751Sd Only)
Scrolls the display information if pressed and held. SCRL DISP ■ Enters clock adjustment mode directly (page 6) if pressed and held while in clock display screen. KDC-BT41U/ KDC-BT31U only: ■ Enters Bluetooth mode. (page 16) ■ Press to answer an incoming call. -
Page 6: Getting Started
Getting Started Canceling the display demonstration The display demonstration is always turned on unless you cancel it. When you turn on the power (or after you reset the unit), the display shows: [CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB] Press the volume knob. [YES] is selected as the initial setup. -
Page 7: Initial Settings Before Operations
OFF */ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for optimum performance. F/W UP xx.xx YES: Starts upgrading the firmware. ; NO *: Cancels (upgrading is not activated). For details on how to update the firmware, see: www.kenwood.com/cs/ce/ Selectable setting (Preset: *) English... -
Page 8: Listening To The Radio
Listening to the Radio Hold to turn on or off the Traffic Information function (not applicable if “MW/LW” is selected). ■ Hold for about 2 seconds to memorize the current station or the selected Program Type. (Refer to [PTY SEARCH] on the table below to select the Program Type.) ■... - Page 9 Item AUTO TP SEEK/ ON *: Automatically searches for a station with better reception when the traffic information’s reception is poor. ATP SEEK ; OFF: Cancels. ■ [NEWS SET/ AF SET/ REGIONAL/ AUTO TP SEEK/ ATP SEEK] is selectable only when the source is “FM”. If other playback source is selected, these settings are selectable under [TUNER SET] item.
-
Page 10: Listening To A Disc/ Usb/ Sd/ Ipod
Listening to a Disc/ USB/ SD/ iPod Detach the faceplate ■ Press to select track/file. ■ Hold to fast-forwards/reverses. Press to select next folder of Audio File/ iPod. Start playing a disc Press SRC to turn on the power. Insert a disc into the loading slot. Playback starts automatically. -
Page 11: Start Playing An Sd
4/ ¢ skips songs at 10% regardless of the setting made. (page 13) This operation is effective only for the iPod or Kenwood Music Editor media. ■ To return to the root folder (audio file), top menu (iPod) or first track (audio CD), press BAND. -
Page 12: Alphabet Search For Ipod
Alphabet Search for iPod • Function of KDC-BT41U/ KDC-4751SD. Press to enter Music Search mode. “SEARCH” appears. Turn the volume knob to select a category, then press to confirm. Press again to enter alphabet search mode. “SEARCH <– – –>” appears. -
Page 13: Adjust [Settings] Mode Settings
Adjust [SETTINGS] mode settings While listening to an iPod or KENWOOD Music Editor media ... Press the volume knob to enter [FUNCTION] mode. Turn the volume knob to select [SETTINGS], then press to enter. Turn the volume knob to make a selection, then press to confirm. - Page 14 In this case, “RESUMING” is displayed without displaying a folder name, etc. Changing the browse item will display a correct title, etc. ■ You cannot operate iPod if “KENWOOD” or “✓” displayed on iPod. About “KENWOOD Music Editor” ■ This unit supports the PC application “KENWOOD Music Editor Light ver1.1”...
-
Page 15: Listening To The Other External Components
Listening to the other external components Preparation : Make sure [ON1] or [ON2] is selected for [BUILT-IN AUX/ BUILTIN AUX]. (page 7) Press SRC to select “AUX”. Turn on the external component and start playing. Turn the volume knob to adjust the volume. -
Page 16: Operation Of Hands-Free Phoning
Operation of Hands-Free Phoning Function of KDC-BT41U/ KDC-BT31U ■ Press to enter Bluetooth mode. ■ Press to answer an incoming call. Getting Started Before use the cell-phone, you need to connect cell-phone to this unit. Press and hold to enter easy pairing mode “PAIRING”... -
Page 17: Receiving A Call
■ To return to the Phone Book mode, press Press the volume knob to start searching. Turn the volume knob to select a name and category. To move to the next character, press 4 ■ / ¢. Press the volume knob to make a call. ■... -
Page 18: During A Call
During a Call Disconnecting a Call Press SRC. Switching to the Private Mode Press number button 6 to switches between Private talk (“PRIVATE TALK”/ “PV TALK”) and Hands-free talk (“HANDS FREE”/ “HF TALK”). Call Waiting Answering Another Incoming Call with the Current Call Suspended Turn the volume knob to select [ANSWER], then press to enter. -
Page 19: Bluetooth Setup
Bluetooth Setup Function of KDC-BT41U/ KDC-BT31U Easy Pairing function Press and hold to enter easy pairing mode “PAIRING” is displayed. ■ Any of the following is displayed depending on cell-phone registration condition: “SEARCHING”: When registering a cell- – phone for the first time. -
Page 20: Registering Bluetooth Device (Pairing)
Start registering this unit by operating the Bluetooth device. By operating the Bluetooth device, register the hands-free unit (pairing). Select “KENWOOD BT CD/R-3P1” from the list of connected units. Input the PIN code (“0000”) in the Bluetooth device. Check that registration is complete on the Bluetooth device. -
Page 21: Setting A Voice Command
Setting a Voice Command Registering Phone Book Name Press to enter Bluetooth mode. Turn the volume knob to select [SETTINGS], then press to enter. Turn the volume knob to select [VOICE TAG], then press to enter. Turn the volume knob to select [PB NAME EDIT]/ [PB NAME EDT], then press to enter. -
Page 22: Bluetooth Setup
Bluetooth Setup Press to enter Bluetooth mode. Turn the volume knob to select [SETTINGS], then press to enter. Turn the volume knob to make a selection, then press to confirm. ■ See table below for selection. ■ Repeat step 3 until the desired item is selected/activated. ■... - Page 23 –2 — 0 * — +2: Adjust the level of echo cancellation. Setting to “+” increases the echo cancel reduction. MIC SELECT KDC-BT41U only Determines whether the built-in or external microphone is to be used when the receiver incorporates a microphone.
-
Page 24: Sms (Short Message Service)
SMS (Short Message Service) Function of KDC-BT41U/ KDC-BT31U Press to enter Bluetooth mode. Downloading the SMS Press to enter Bluetooth mode. Turn the volume knob to select [SETTINGS], then press to enter. Turn the volume knob to select [SMS DOWNLOAD]/ [SMS DL], then press to enter. - Page 25 ■ To exit Bluetooth mode, press ■ The unopened message is displayed at the beginning of the list. Other messages are displayed in the order of reception. ■ The SMS that has arrived when the cell- phone is not linked with Bluetooth cannot be displayed.
-
Page 26: Function Settings
Function settings Press SRC to select a source other than “STANDBY”. Press the volume knob to enter [FUNCTION] mode. Turn the volume knob to select [AUDIO CONTROL/ AUDIO CTRL] or [SETTINGS], then press to enter. Turn the volume knob to make a selection, then press to confirm. ■... - Page 27 Item HPF REAR THROUGH *: All signals are sent to the rear speaker. ; 40/60/80/100/ 120/150/180/220 (HZ): Frequencies lower than the specified value are cut off. THROUGH *: All signals are sent to the subwoofer. ; SUBWOOFER/ 50/60/80/100/120 (HZ): Frequencies higher than the specified value are cut off. LPF SUB-W SUB-W PHASE REVERSE/ REV (180°)/ NORMAL/ NORM (0°) *: Selects the phase angle of the subwoofer output to be in...
-
Page 28: Installation/Connection
(do not mix front and rear). ■ Mounting and wiring this product requires skills and experience. For safety’s sake, leave this work to professionals. If you experience problems during installation, consult your Kenwood dealer. - Page 29 ■ Reception may drop if there are metal objects near the Bluetooth antenna. Bluetooth antenna unit For Good Reception To assure good reception, note the following: ■ Communicate with the cell-phone within the line-of-sight distance of 10 m (30 ft). The communication range becomes shorter depending on the surrounding environment.
-
Page 30: Wiring Connection
Ignition (ACC) Black Earth (ground) connection English FM/AM antenna input (JASO) To connect the Kenwood navigation system, consult your navigation manual. MUTE (Connect to the terminal that is grounded when either the telephone rings or during conversation. KDC-4751SD only) To use the steering wheel remote control feature,... - Page 31 Installing the unit Before attaching, make sure the direction of the escutcheon is correct. (Wider hooks on the bottom side.) Removing the unit Detach the faceplate A. Engage the catch pin on the removal tools E into the holes on both sides of the escutcheon B, then pull it out.
- Page 32 Installation the Microphone Unit (KCA-MC10 ; optional accessory) (KDC-BT41U only) Check the installation position of the microphone. Remove oil and other dirt from the installation surface. Install the microphone. Wire the microphone cable up to the hands-free box with it secured at several positions using tape or the like.
-
Page 33: Troubleshooting
Troubleshooting Symptom Sound cannot be heard. “PROTECT” appears and no operations can be done. The unit does not work at all. Radio reception is poor. / Static noise while listening to the radio. “IN” flashes. CD-R/CD-RW cannot be played back and tracks cannot be skipped. - Page 34 Symptom Correct characters are not displayed (e.g. album name). Bluetooth Symptom The hands-free talk volume is low. The hands-free talk volume can be adjusted independently. Adjust it during hands-free talk. [MIC GAIN], [NR LEVEL] and [EC LEVEL] of <Bluetooth Setup> (page 22). No beep is heard at reception of an No beep is heard depending on the type of your cell-phone.
-
Page 35: Specifications
Input maximum voltage: 1,200 mV Input impedance: 10 kΩ General Operating voltage: KDC-BT41U/ KDC-BT31U: (10.5 V — 16 V allowable): 14.4 V KDC-4751SD: (11 V — 16 V allowable): 14.4 V Maximum current consumption: 10 A Installation size (W × H × D): 182 mm ×... - Page 36 Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for EU countries that have adopted separate waste collection systems) Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items and their...
- Page 37 The “AAC” logo is a trademark of Dolby Laboratories. ■ The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Kenwood Corporation is under license. Other trademarks and trade names are those of their respective owners. ■...
- Page 38 Declaration of Conformity with regard to the EMC Directive 2004/108/EC For KDC-BT41U/ KDC-BT31U Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC Manufacturer: Kenwood Corporation 2967-3 Ishikawa-machi, Hachioji-shi, Tokyo, 192-8525 Japan EU Representative’s: Kenwood Electronics Europe BV Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands...
- Page 39 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen. Slovensko S tem Kenwood izjavlja, da je ta KDC-BT41U/ KDC-BT31U v skladu z osnovnimi zahtevami in ostalimi ustreznimi predpisi Direktive 1999/5/EC. Slovensky Spoločnosť Kenwood týmto vyhlasuje, že KDC-BT41U/ KDC-BT31U spĺňa zákldné...