Configuring The Switch Using The Cli; Starting The Terminal-Emulation Software; Connecting To A Power Source - Cisco Catalyst 9400 Series Hardware Installation Manual
Hide thumbs
Also See for Catalyst 9400 Series:
- System management configuration manual (458 pages) ,
- Installation note (32 pages) ,
- Troubleshooting manual (14 pages)
Table of Contents
Advertisement
Configuring the Switch Using the CLI
Configuring the Switch Using the CLI
Starting the Terminal-Emulation Software
To start the terminal emulation software, follow these steps:
Before you begin
The terminal-emulation software—frequently a PC application such as Hyperterminal or ProcommPlus—makes
communication between the switch and your PC or terminal possible.
Procedure
Step 1
Start the terminal-emulation program if you are using a PC or terminal.
Step 2
Start a terminal-emulation session.
Step 3
Configure the baud rate and character format of the PC or terminal to match these console port default
characteristics:
• 9600 baud
• 8 data bits
• No flow control
• 1 stop bit
• No parity
What to do next
Connect to a power source.
Connecting to a Power Source
To connect to a power source, follow these steps:
Procedure
Step 1
Connect one end of the supplied country-specific AC power cord to the power connector on the switch.
Step 2
Plug the other end into a grounded 100 to 240 VAC, 50–60 Hz AC outlet.
The switch powers on.
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
168
Initial Configuration for the Switch
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
