Related Manuals for AEG AS-M2-G Series
Summary of Contents for AEG AS-M2-G Series
- Page 1 AEG SOLAR MODULES INSTALLATION MANUAL GLASS-GLASS (DOUBLE GLASS) MODULE SERIES: AS-MXXX2-G AEG GLASS-GLASS MODULE INSTALLATION MANUAL VERSION: GD202008 V1-20...
-
Page 2: Table Of Contents
CONTENTS INSTALLATION MANUAL 1. 1 Icons 1.2 Product Identification 2. Safety Thank you for choosing the reliability of AEG glass- 2. 1 General safety glass solar modules. 2.2 Handling safety 2.3 Installation safety This installation manual is intended for dealers and 2.4 Fire safety... -
Page 3: Product Identification
2.1 General safety EN 50380 Directives it provides information about the main parameters of the module: Product Type, All AEG PV modules should be installed according to Maximum Power, Current at Maximum Power, Voltage all local and national applicable standards, codes and at Maximum power, Open Circuit Voltage, Short Circuit regulations. -
Page 4: Installation Safety
2.4 Fire safety during transportation and installation of the electrical equipment. AEG PV modules are tested according to the provisions of IEC EN 61730 Directive with Application Class A. Fire Cover the module completely with a dark opaque safety has been rated as Class C. -
Page 5: General Remarks
If the modules are unpacked but not installed AEG PV modules must be installed and stored in the immediately, please wrap the connectors to prevent following conditions: damage caused by wind or rain. Do not use any... -
Page 6: Bolting
PV module Bolt anticipated wind load and snow load for the area. Flat washer Frame Clamp A AEG glass-glass PV modules can be installed with: • frame mounting holes and bolts – See 3.2. 1 “Bolting” Flat washer Spring washer •... -
Page 7: Loading Capacity
Please note this could vary according to the different mounting systems and configurations. For standard conditions, low loading capacity applies: AEG modules are tested under a maximum positive pressure of 2400 Pa, and negative pressure of 2400 Pa; they are designed to meet a maximum positive pressure of 1600 Pa, and negative pressure of 1600 Pa. -
Page 8: Electrical Installation
The modules are fitted with two pre-assembled grounding of racking system and/or module frames. sunlight resistant, isolated cable leads, which end with AEG PV Modules use an anodic oxidized aluminum PV fast connectors for the electrical connection of frame; modules should hence be connected to the the system (positive [+] and negative [-] terminals). -
Page 9: Maintenance
Dirt and dust can accumulate on the glass surface of 3) Additional third-party grounding devices the PV module over time, particularly in installations AEG solar modules can be grounded using third-party with low inclination. This can cause a general decrease grounding devices. It is required that these devices are... -
Page 10: Module End Of Life
For any question please contact us: Solar Solutions GmbH Brückenstrasse 94 60594 Frankfurt am Main Germany www.aeg-industrialsolar.de Mail: service@aeg-industrialsolar.de Tel: +49 (0)69400500810 AEG is a registered trademark used under license from AB Electrolux (publ). AEG GLASS-GLASS MODULE INSTALLATION MANUAL GD202008 V1-20...