hit counter script
Toshiba BMS-LSV4E Installation Manual
Toshiba BMS-LSV4E Installation Manual

Toshiba BMS-LSV4E Installation Manual

Bacnet software (for intelligent server)

Advertisement

INSTALLATION MANUAL
TM
BACnet
SOFTWARE
Model:
BMS-STBN
E
(for Intelligent Server model BMS-LSV4E only)
• Thank you very much for purchasing this TOSHIBA BACnet Software.
• Please read this manual carefully beforehand for proper installation of the software.
CONTENTS
Precautions for Safety .................................................................................................................... 1
Before Installation .......................................................................................................................... 1
Elements of the Intelligent Server ................................................................................................. 2
1 CF (Compact Flash) card Installation ....................................................................................... 3
2 Setting .......................................................................................................................................... 3
3 Installation.................................................................................................................................... 4
4 Cable Connection ....................................................................................................................... 6

Advertisement

Table of Contents
loading

Summary of Contents for Toshiba BMS-LSV4E

  • Page 1: Table Of Contents

    SOFTWARE Model: BMS-STBN (for Intelligent Server model BMS-LSV4E only) • Thank you very much for purchasing this TOSHIBA BACnet Software. • Please read this manual carefully beforehand for proper installation of the software. CONTENTS Precautions for Safety ........................1 Before Installation .......................... 1 Elements of the Intelligent Server ....................
  • Page 2: Precautions For Safety

    Failure to do so may result in disconnection, overheating, or fire. Before Installation NOTE This CF (Compact Flash) card is the software for the Intelligent Server (Model: BMS-LSV4E) only. Prepare the Intelligent Server to use this card. This card is not applicable to BMS-LSV2E. Check the following package contents.
  • Page 3: Elements Of The Intelligent Server

    Elements of the Intelligent Server Front view INTELLIGENT SERVER RUN LED (green) LON T/R LED (green) General-purpose LED1 (green) END LED (green) General-purpose LED2 (green) General-purpose switch 2 Maintenance switch Error indication LED (red) Shutdown request switch General-purpose switch 1 Reset switch SERVICE LED (green) LON service switch...
  • Page 4: Cf (Compact Flash) Card Installation

    CF (Compact Flash) card Installation REQUIREMENT • Do not insert or remove the CF (Compact Flash) card during power on of the Intelligent Server. Doing so may cause a failure. • If the CF (Compact Flash) card is not inserted properly, the Intelligent Server will not work. Insert the attached CF (Compact Flash) card fully into the CF (Compact Flash) card slot on the side of the Intelligent Server.
  • Page 5: Installation

    Installation Intelligent Server Installation Method and Orientation There are two ways to install the Intelligent Server as shown below: (1) rack mount (2) surface mount. The rack mount installation requires a support bracket for a 19-inch rack. Please contact us if you need the support bracket.
  • Page 6 Installation (continued) Installation Space and Maintenance Space The installation space and the maintenance space must be determined before installation. These spaces depend on installation method. Installation Space The values in the following table are required for installation space in each direction. Select an installation place that allows good air ventilation.
  • Page 7: Cable Connection

    Cable Connection AC Power Cable Connection REQUIREMENT Power cable is not supplied for the Intelligent Server. Prepare a 3-core power cable conforming to applicable safety standards. Be sure to connect the earth line of the power cable securely. • Insert an AC power cable into the AC inlet of the unit. •...
  • Page 8 Appearance and Size WARNING Do not decompose. Unit in mm NOTE Trial operation should be checked by professional service personnel. Trademarks: • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •...

Table of Contents