Related Manuals for Zanussi ZGF 983
Summary of Contents for Zanussi ZGF 983
-
Page 1: Gas Hob
TABLE DE CUISSON GASKOOKPLAAT GASKOCHMULDE GAS HOB ZGF 983 NOTICE D'UTILISATION GEBRUIKSAANWIJZING GEBRAUCHSANLEITUNG INSTRUCTION BOOKLET... -
Page 2: For Your Safety
• Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Refer to your local Zanussi Service Centre. Always insist on genuine Zanussi spare parts. • Ensure that all control knobs are in the OFF position when not in use. -
Page 3: Table Of Contents
Contents 1. Instruction for the User ... Pag. 2. Cleaning and Maintenance ... Pag. 3. Technical Data ... Pag. 4. Instruction for the Installer ... Pag. 1. Instruction for the User HOB BURNERS CONTROL KNOBS The hob burners control knobs are situated on the hob front panel. -
Page 4: Cleaning And Maintenance
In order to make the appliance match with the kitchen design, a lid (not provided) can be fitted on the hob. The lid is meant to avoid dust to settle on the hob, when it is closed, and to collect splashes of oil or fat, when it is open. -
Page 5: Technical Data
3. Technical Data Gas Burners Rating Double Crown Burner Rapid Burner (big) 3 kW (G20) - 2,8 kW (G30-31) Auxiliary Burner (small) Semirapid Burner (medium) Class 3 Appliance Category Setting Natural Gas 20 mbar / G25 25 mbar 4. Instruction for the Installer The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. -
Page 6: Electrical Connection
5. Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label);... -
Page 7: Adaptation To Different Types Of Gas
6. Adaptation to different types of gas INJECTORS REPLACEMENT • Remove the pan supports. • Remove the burner's caps and crowns. • With a socket spanner 7 unscrew and remove the injectors (Fig. 7), and replace them with the ones required for the type of gas in use (see table 2). -
Page 8: Building In
7. Building In A = Auxiliary burner SR = Semirapid burner R = Rapid Burner UR = Double Crown Burner These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. -
Page 9: Guarantee
INSTALLATION AND ASSEMBLY These hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. 13. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the cut out edges must have a minimum distance of 150 mm. - Page 10 POSSIBILITIES FOR INSERTION Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig.