Page 2
Parts and features Copy your Model and Serial When you need service or (call with a question, have this informatlon ready Model and Serial Num- 1. Complete bers (from the plate located shown). 2. Purchase date from sales slip. Copy this information in these spaces.
Other Operating Instructions Cleaning the Lint Filter DRYER Starting Your Dryer. Operating Instructions Selecting a Cycle. 8,~ 1985 Whirlpool Your responsibilities Read this”Use and Care Guide”and carefully for important use and safety You are personally responsible for installation. washer /dryer...
Before using your THIN TWIN* washer dryer For best washing and drying results, you must take some very steps before, during and after each load: 1. Prepare and sort each load for washing 2. Measure and add detergent or soap to washer 9-10).
Starting your washer Select 1. LOAD SIZE 0 Turn the knob to point at a setting that describes the size of load you want to wash The water level can be set for EX SMALL, MEDIUM or LARGE loads Select the water level that matches the load size...
Page 7
Select CYCLE and WASH Start the washer Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwise Start the washer by pulling the Control Knob. The washer will fill to the level You set with wash water of the selected temperature.
What happens in each cycle Each cycle has different agitation kinds of fabrics. Numbers on the dial agitation time. When the Cycle Control Knob is set to a number fills before agitation timing starts. After agitation REGULAR HEAVY Cycle A cycle structed heavily soiled.
Page 9
clockwise until it points to OFF and the cycle NOTE:You hear the sound of water some cycles. In some CyCles, cold help with the rinsing. PARTIAL DRAIN [Pause) NOTE: Always Pre-wash setting begins Special care is needed when soaking See your”laundry Guide”...
Other operating instructions For a rinse and spin You may need an extra rinse and spin for heavily solled loads which need more detergent. (Extra de- tergent can require an extra rrnse ) Push Control Knob In 9 Turn clockwrse to any.on the dial See above...
Starting Before starting properly [see your “Laundry Select CYCLE and TIME Turn the Control point to the time setting the cycle you want. To stop and restart the dryer To stop. open the door Control Knob to OFF). To restart, close the door and push the START button.
Operating instructions The automatic cycles The automatic cycles allow you to select the degree of dryness prefer for the clothes being dried. The Control Knob moves and stops several times until the load reaches the dryness setting you selected. Then the knob automatically moves to OFF and tumbling...
Drying tips TI le dryer does not heat when the Control Knob is set on AIR. This setting can be used to fluff bedding, plastic tablecloths, foam rubber pillows, stuffed toys, sneakers, etc. TUMBLE PRESS Setting The TUMBLE PRESS setting removes wrinkles from dry clothing...
Lint screen Clean the lint screen before each increase drying time and may be a FIRE HAZARD. The lint screen Inside the dryer pull drum, on the Dack wall I. Use tno finger holes 73 pull screen ?‘-te III’ WARNING: DO NOT run the dryer with the lint screen loose, damaged...
Caring for your washer When not washing, keep both water faucets turned off. This takes the pres- sure off the water inlet valve and hoses. Never use the washer to... soak for more than 2 hours soak with chlorine bleach. soak with vinegar or other acids.
Vacation care 2. Unplug 3. Clean Winterizing Install and store your washer) dryer where some water stays In the washer, freezing dryer stored or dur ng freezing moved Shut off both water 2. Put (:I quart of auto- faucets Disconnect motXile-type and drain water freeze...
If you need service or assistance, we suggest you follow these four steps: 1, Before calling for assistance... Performance problems often result from little things you can find and fix yourself without tools of any kind. If your washer does not fill: Is the power supply cord...
Corporation quality parts Look for this symbol of quality whenever you need a replacement part @ tor your Whirlpool appliance. FSP replacement parts wll fit right ond work right, because they are mode to the some exacting specihcations used to build...
Page 20
Making your world a little easier. Part No. 693016 a1985 Whirlpool Corporation Printed in U.S.A.