Parts and features LAUNDRY INFORMATION Copy your Model and Serial Numbers here When you need service or call with a question, have this information ready: Model and Serial Numbers 1. Complete (from plate under the lid near the hinge). 2. Purchase date from sales slip. Copy this information in these spaces.
Starting your washer Before starting 1. Measure and add detergent your washer: 2. Place sot-ted load in washer. 3. Start the washer. 1 Select CYCLE and WASH TIME; L Start the washer Push In the Control Knob and It must be turn It to the right.
Page 5
To select a WASH TEMPERATURE can be selected by HOT WATER turning the Control Knob to 12 or 14 mlnutes in the REGULAR HEAVY Cycle. All rinses use cold water. Thls saves energy and helps prevent wrinkles tram setting Into place. To select a WATERLEVEL The washer will...
What happens in each cycle* Each cycle has been designed for different kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH agitation time. When the Cycle Control Knob is set to a number and pulled out, the washer fills before agitation and timing starts.
Page 7
NOTE: You may hear the sound of water spraying during the spin parts of Some cycles. In some cycles, cold water is sprayed on the spinning load to help with the rinsing.
Other operating instructions For a rinse and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.) Push Control Knob in. 2. Turn clockwise to any on the dial.
Caring for your wa keep both WHEN NOT WASHING, water faucets turned off, this takes the oressure off the water inlet valve and such as REMOVE SHARP OBJECTS pins, buckles, etc., from clothes before washing. Close metal zippers. use a soft dry cloth to AFTER WASHING, wipe the outside and inside dry.
Winterizing Because some water stays in the washer, freezing can cause a lot of damage. If your washer is stored or during the cold weather... moved 1. Shut off both water 2. Put a quart of faucets. Disconnect automotive-type and drain water antifreeze in the inlet hoses.
(see Step 2) and talk with one of our Consultants, or if you pre- fer, write to: Mr. Robert Stanley Division Vice President Whirlpool Corporation 2000 US-33 North Benton Harbor, Ml 49022 If you need FSP” replacement parts:.. FSP is a registered...
God or use of products not approved E. Any labor costs during the llmited warranties. WHIRLPOOL CORPORATION SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSE- QUENTIAL DAMAGES. Some states do not allow the exclusion lncldental...