Cisco CSS8-IDM-MEM-HD Quick Start Manual

Internal disk module

Download this manual

Internal Disk Module (IDM) Reference

Product Number: CSS8-IDM-MEM-HD=

The CSS-11800 contains a Internal Disk Module (IDM) under the control of the master SCM. The IDM functions as a

data-logger and system software repository and must be installed in slot 15 of the CSS 11800 chassis.

Removing the IDM

To remove the IDM:

Properly ground yourself prior to handling the module. For example, wear

an anti-static wrist strap (included in the Accessory kit) and stick the

copper-tape end of the strap to an unpainted metal surface on the chassis.

Make sure that the wrist strap makes good contact with your skin

If necessary, power down the CSS.

Using a Phillips screwdriver, remove the two captive screws securing the

module to the chassis.

Grasp the module extractors and gently slide the disk module from the

chassis.

Replacing the Internal Disk Module

You must power down the CSS to install an IDM.

To install an IDM:

If necessary, power down the CSS.

Insert the IDM into the board guides at the top and bottom of slot 15 and slide it into the chassis by pressing firmly at

the top and bottom of the faceplate.

Close both ejectors simultaneously to seat the connector into the backplane.

Using a Phillips screwdriver, tighten the screws on the front of the module faceplate.

Boot up the CSS.

Document Number: 78-11507-01

June 2003

Page 1 Internal Disk Module (IDM) Reference Product Number: CSS8-IDM-MEM-HD= The CSS-11800 contains a Internal Disk Module (IDM) under the control of the master SCM. The IDM functions as a data-logger and system software repository and must be installed in slot 15 of the CSS 11800 chassis.
Page 2 Using the Internal Disk Module LEDs The Internal Disk Module (IDM) contains Power, Status, and Active LEDs. Table 1 describes the IDM LEDs and their indications. Power LED Status LED Table 1. Internal Disk Module LED Descriptions Active LED LED Name Color Status Indicates...
Page 3 The software directory also contains the startup-config file. This file is an ASCII file containing commands the CSS executes at startup. This file is created when you: • Complete using the configuration script. • Issue the copy running-config startup-config or write memory command. These commands also save configuration changes to the startup-config during a CSS session.
Page 4 June 2003 Document Number: 78-11507-01...