Set Up Your Handset Automatically; Set Up A Handset Automatically With The Username And Password - Cisco IP DECT 6800Series User Manual
Hide thumbs
Also See for IP DECT 6800Series:
- Administration manual (358 pages) ,
- User manual (222 pages) ,
- Provisioning manual (104 pages)
Table of Contents
Advertisement
Handset Setup
Set Up Your Handset Automatically
In many cases, when you first power-on the handset, it automatically starts to configure itself to communicate
with the base station. You may get further instructions if there are choices or additional information.
When your handset successfully registers, you see the Registered message, and then the idle screen is
displayed.
Procedure
Step 1
Press and hold Power/End
The handset displays Search for base station.
Step 2
If the handset displays a list of base stations, press down on the navigation ring to highlight the base station
that you need to connect to and press Select.
Step 3
If the handset displays Enter the code, contact your administrator for the base station access code.
Step 4
If the screen doesn't display the Registered message, make note of the error message and contact your
administrator or service provider for assistance.
Set Up a Handset Automatically with the Username and Password
When you power on a new handset, it automatically registers itself with the base station which is in promiscuous
mode. If the server requests authorization, you enter the username and password. When you need to register
multiple handsets, we recommend that you power on one handset to enter the credentials. The other handsets
don't receive the authorization request when they register.
The username and password can be a combination of letters, numbers, and symbols. The username can be
between 1 and 24 characters and password can be between 1 and 128 characters.
If you enter a wrong username or password, an error message displays. You have three attempts to enter the
correct username and password. If you fail all the attempts, the handset deregisters from the base station.
Restart the handset and enter the correct username and password, or contact your administrator.
Before you begin
Your administrator or service provider gives you the username and password.
Procedure
Step 1
Press and hold Power/End
Step 2
Enter the Username and Password in the Sign in screen.
Step 3
Press Submit.
until the screen turns on.
until the screen turns on.
Set Up Your Handset Automatically
Cisco IP DECT 6800 Series User Guide
29
- Quick Links:
- Automatic Handset Configuration
Hide quick links:
Advertisement
Table of Contents
