Table of Contents
Advertisement
Using your freezer
.*~~ypsesa*
...&.*~*+e,
I!<?&
'2Js
i .i. '::". -:s;,i ?. .'r@C
. , :.
Setting the temperature
control...
I. Insert a corn rn the slot of the Temperature
Control to
1 Turn control to higher number for colder temper-
turn it.
atures.
2. Turn control to Number 3 This setting is desrgned to
2 Turn to lower number
for less cold temperatures.
matntarn the temperature
at or near 0°F ( -- 17.8%)
under normal operating
conditions
Cooling freezer first...
1 Allow freezer to cool 6 to 8 hours before filling with
frozen
food.
2 Let it cool overnight
before adding
large amount
of unfrozen
tood.
NOTE: When freezer is first started the compressor
will
run constantly
until the cabinet
is cooled. It may take
up to 6 to 8 hours or longer, depending
on room tem-
perature
and the number of times the freezer lid is
opened
After the cabinet
is cooled the compressor
will
turn
on and off as needed
to keep freezer at proper
temperature.
loadrng or unloading
food below it
To remove:
Lift baskei out
To replace:
Lower basket Into place
The key eject lock...
cun
help
reduce
the
hazard
of
child
The sliding basket...
Can be moved from side to stde or removed
when
To lock or unlock the freezer you must hold the
key In the lock while turnrng
The lock is sprrrlg
loaded
so the key cannot
be left in the lock.
If the key IS lost, contact
your WHIRLPOOL
dealer
for a replacement
Always give the com-
plete
model
and serial number
of your freezer
when requesting
a replacement
key.
entrapment
s.--.--
-x
-.,
The signal light...
automatically
warns
of any unexpected
power
If the signal light is not glowing,
immediately
check:
l
for power interruption,
failure.
l
for an unplugged
power cord,
2. Carefully snap out light cover and assembly with a
To replace:
screwdriver
by inserting it under the end of metal
edge
of the light. Be careful not to chip finish on
1. Unplug power cord from outlet.
freezer.
Signal
light
3. Unplug burned out signal light and replace
with a
new one. Signal light can be ordered
from your
WHIRLPOOL dealer
4. Then, snap light assembly
into place.
5. Plug power cord into outlet.
Advertisement
Table of Contents
