Replacing The Cover - Cisco 3600 Series Configuration Note

Memory upgrade

Hide thumbs Also See for 3600 Series:

Table of Contents

Replacing the Cover

After you ﬁnish replacing memory, follow these steps to replace the cover:

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Figure 16

Place the chassis bottom so the front panel is closest to you.

Hold the cover so the tabs at the rear of the cover are aligned with the chassis bottom, as

shown in Figure 16 and Figure 17.

Push the cover toward the rear, making sure that the cover tabs ﬁt under the chassis back

panel, and the back panel tabs ﬁt under the cover.

Lower the front of the cover onto the chassis, making sure that the cover side tabs ﬁt under

the chassis side panels, and the chassis tabs ﬁt under the cover side panels.

Fasten the cover with the three screws you set aside earlier.

Reinstall the chassis on a rack, wall, desktop, or table.

Reinstall network interface cables, as described in the following section, "Replacing

Connections to the Router."

Replacing the Cisco 3620 Cover

Cisco 3600 Series Memory Upgrade Configuration Note

Replacing the Cover

Table of Contents