Cisco Catalyst 2900 XL Series Installation And Configuration Manual page 47
Atm modules
Hide thumbs
Also See for Catalyst 2900 XL Series:
- Hardware installation manual (138 pages) ,
- Quick start manual (13 pages) ,
- Brochure (411 pages)
Table of Contents
Advertisement
If this Step is successful, the remaining Steps are not necessary. Otherwise, go
to Step 5.
Step 5
(Optional) If Steps 1 through 4 did not provide successful results, enter the
following command to ensure that the defective IOS image does not come up:
Switch# hw-module 1 maint
Using this command allows you to bypass the IOS image and connect to the
module through the boot loader when you restart the module.
Restart the module using the following command:
Step 6
Switch# hw-module 1 restart
(Optional) Enter the copy command to copy the image.
Step 7
Switch# copy tftp://server//filename slot1:boot
Step 8
(Optional) Restart the module by entering the following command:
Switch# hw-module 1 restart
Step 9
If there is still a problem, do one of the following:
•
Restart the switch by entering the reload command.
Switch> reload
•
Ensure that there is enough space available on the module by entering the dir
command.
Switch> dir slot1
Switch> dir slot2
Troubleshooting 4-3
Advertisement
Table of Contents
