Groomer Binding Troubleshooting - Toro Reelmaster 3550 Series Operator's Manual
Right/left-hand groomer kit, 18-inch cutting unit
Hide thumbs
Also See for Reelmaster 3550 Series:
- Operator's manual (24 pages) ,
- Installation instructions manual (16 pages)
Table of Contents
Advertisement
Groomer Binding
Troubleshooting
1. Make sure that the groomer is set to the desired height
of groom (HOG); refer to Figure 26.
1. Quick-up lever (engaged
position)
2. Groomer height (HOG)
2. Loosen the quick-up mounting bolt and make sure
that the threaded rod is in line and not binding on the
bottom quick-up ramp (Figure 27). Tighten the bolts.
3. Check the length of the quick-up springs on the
threaded rods, the length should be 3.5 cm (1-3/8
inches); refer to Figure 27.
1. Quick-up mounting bolt
4. If the height-adjuster knob does not rotate freely, the
bushing may be dirty (Figure 27). Clean the bushing
if necessary.
Figure 26
3. Height-adjuster knob
4. Number of rear roller
spacers (below side-plate
pad)
Figure 27
2. Height-adjuster knob
5. Make sure that the main drive bushing (Figure 28)
pivots freely around the drive hub.
1. Main drive bushing
6. Make sure that the shim (Figure 29) between the drive
side groomer pivot plate and the cutting-unit side plate
is not pinched by the pivot hub. The shim must be able
to move freely.
1. Shim
7. Make sure that nuts on the covers (Figure 30) are not
over-tightened.
1
1. Groomer cover
14
Figure 28
Figure 29
2
G021755
Figure 30
2. Access cover
Advertisement
Table of Contents
