VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
staff kitchen areas in shops, offices and other working – environments; by clients in hotels, motels, bed & breakfast and other – residential type environments; areas for communal use in blocks of flats or in launderettes. – Do not exceed the maximum load of 8 kg (refer to the •...
• Make sure that there is air circulation between • When unpacking the appliance, It is possible to the appliance and the floor. see water flowing from the drain hose. This is • When the appliance is in its permanent position, due to the testing of the appliance with the use check if it is levelled correctly with the aid of a of water in the factory.
DISPOSAL • Remove the door catch to prevent children or pets from becoming trapped in the drum. WARNING! Risk of injury or • Dispose of the appliance in accordance with suffocation. local requirements for the disposal of Waste Electrical and Electronic Equipment (WEEE). •...
If you install the appliance on a plinth, secure the Read carefully the instructions supplied with the appliance in the fixing plates. accessory. TECHNICAL DATA Dimension Width/ Height/ Total depth 59,7 cm /84,7 cm /56,8 cm Electrical connection Voltage 230-240 V Overall power 2200 W Fuse...
hose from the hose holders. 1. Install the appliance on a flat hard floor. The appliance must be levelled and stable. Make sure that the appliance does not touch the wall or other units and there is air circulation below the appliance.
Page 8
It is possible to connect the drain hose in different ways: 1. Make a U shape with the drain hose and put it around the plastic hose guide. 2. On the edge of a sink - Fasten the guide to the The end of the drain hose must always water tap or to the wall.
Page 9
INSTALLATION ON SUSPENDED FLOORING Suspended wooden floors are particularly susceptible to vibration. To limit vibration we recommend placing a waterproof wooden panel, at least 15 mm thick, under the appliance. It should be screwed to at least 2 floor beams and should extend beyond the front feet.
EASY START This appliance is designed with a self cleaning SPECIAL FEATURES draining system, allowing light fluff fibers that fall off the clothes to be drained out with the water, in Your new washing machine meets all modern such a way that there is no need to access this requirements for an effective treatment of laundry area for regular maintenance and cleaning.
PROGRAMME CHART Programme Maximum load Programme description Default temperature Reference spin (Type of load and level of soiling) Temperature range speed Eco 40-60 8 kg White cotton and fast-coloured cotton. Normally 1400 rpm soiled items. The energy consumption decreases and the 40 °C time of the washing programme is extended, ensuring 60 °C - 30 °C...
Page 12
Programme Maximum load Programme description Default temperature Reference spin (Type of load and level of soiling) Temperature range speed 30'@ 30° 3 kg A short cycle for lightly soiled synthetic and delicate 30°C 700 rpm items or for items to freshen up. 1) According to Commission Regulation EU 2019/2023, this programme at 40 °C is able to clean normal- ly soiled cotton laundry declared to be washable at 40 °C or 60 °C, together in the same cycle.
Page 13
Programme Delay Start Quick ■ Duvets ■ ■ ■ ■ Jeans ■ ■ 30'@ 30° 1) When you set the Quick option, we recommend that you decrease the quantity of the laundry. It is pos- sible to keep the full load but the washing results can be unsatisfactory. Recommended load: cotton: 4 kg, synthetics and delicates: 1,5 kg.
The related indicator comes on. There is a water in the drum when the programme is completed. The door stays locked. You must drain EXTRA RINSE the water to unlock the door. To With this option you can add some rinses to a drain the water refer to ‘At the end washing programme.
Compartment for liquid additives (fabric conditioner, starch). CAUTION! Do not exceed the MAX level. Flap for powder or liquid deter- gent. LIQUID OR POWDER DETERGENT CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry.
Page 16
When you activate an option, the indicator of the set option comes on. If you set something incorrect, the indicator of button Start/Pause flashes red. STARTING A PROGRAMME WITHOUT THE DELAY START Press the button Start/Pause. The corresponding indicator stops to flash. The phase indicator illuminates and stays on.
CANCELLING A RUNNING PROGRAMME • You can open the door. • Remove the laundry from the appliance. Make 1. Turn the programme knob to position sure that the drum is empty. cancel the programme and to deactivate the • Close the water tap. appliance.
• A very small load can cause balance problems load, degree of soiling, wash temperature and with the spin phase leading to excessive hardness of the water used. vibration. If this occurs: • Follow the instructions that you find on - interrupt the programme and open the door packaging of the detergents or other treatments (refer to "Daily Use"...
Use the correct quantity of the water softener. Obey the instructions that you find on the packaging of the product. CARE AND CLEANING WARNING! Refer to Safety chapters. CAUTION! Do not use alcohol, solvents or chemical products. CAUTION! Do not use the metal PERIODIC CLEANING SCHEDULE surfaces with chlorine-based Periodic cleaning helps to extend the life of...
Regularly examine the seal and remove all objects from the inner part. Coins, buttons, other small items forgotten in the pockets of your clothes are deposited during the washing cycle in the special double lip trap in the porthole seal, where they can be conveniently recovered at the end of the cycle.
remaining water from the inlet hose and the drain pump. Do this procedure also when you want to do the emergency drain. 1. Disconnect the mains plug from the mains socket. 2. Remove the water inlet hose. 3. Remove the drain hose from the rear support and unhook it from sink or spigot.
Page 22
• Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. The appliance does not • This problem may be caused by the clogged drain circuit. Please con- drain the water. tact the Authorised Service Centre.
Problem Possible solution • Make sure the levelling of the appliance is correct. Refer to "Installa- The appliance makes an tion instruction". unusual noise and vi- • Make sure that the packaging and/or the transit bolts are removed. brates. Refer to "Installation instruction". •...
Page 24
LEGEND Laundry load. h:mm Programme duration. Energy consumption. °C Temperature in the laundry. Litres Water consumption. Spin speed. Remaining moisture at the end of spinning phase. The higher is the spin speed, the higher is the noise and the lower is the remaining moisture. Values and programme duration may differ depending on different conditions (e.g.
Page 25
Approximate Remaining Energy con- Water con- programme moisture Standard cotton programmes. Load (kg) sumption sumption (li- duration (kWh) tres) (minutes) For Standard 40°C cotton: 0.62 Set Eco 40-60 at 30°C 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0.48 0.48...
ENVIRONMENTAL CONCERNS with the symbol with the household waste. Recycle materials with the symbol . Put the Return the product to your local recycling facility or packaging in relevant containers to recycle it. Help contact your municipal office. protect the environment and human health by recycling waste of electrical and electronic appliances.