Table of Contents
Advertisement
Pinout and LED Details
USB Console Port Pinout
Two individual Type-A USB connector are used for USB console and USB mass storage. One single USB
2.0 Type-A receptacle is provided on the RSP front panel for providing console access to ROMMON, IOS-XE
and diagnostics. It operates as a USB peripheral only for connection to an external host PC. This requires the
use of a Type-A to Type-A connector instead of a standard USB cable.
Note
The use of the USB console is mutually exclusive with the RS232 console/Aux port. While a USB cable is
inserted, access is automatically switched to this port.
The other single USB 2.0 Type-A receptacle is provided on the RSP front panel for inserting external USB
mass storage devices such as standard USB flash drives. It is used to load images, store configurations, write
logs, etc. It supports operation up to 12Mbps
The table below summarizes the USB console port pinout.
Pin
A1
A2
A3
A4
Note
The USB Console port +5VDC is input and operates as an USB peripheral device.
USB Flash/MEM Port Pinout
Table 22: Single USB Flash/MEM Port
Pin
A1
A2
A3
A4
Note
USB TYPE-A receptacle used.
Signal Name
Vcc
D-
D+
Gnd
Signal
Direction
Description
Name
Vcc
+5VDC
(500mA)
D-
Data -
D+
Data +
Gnd
Ground
Direction
Cisco NCS 560-4 Router Hardware Installation Guide
USB Console Port Pinout
Description
+5VDC (500mA)
Data -
Data +
Ground
111
Hide quick links:
Advertisement
Table of Contents
