Honeywell Voyager MS9520 Installation Instructions

Hide thumbs Also See for Voyager MS9520:

How to install the Honeywell (formerly Metrologic) Voyager Scanner

This article covers the steps required to install the Voyager wand scanner for use with the Web

Kiosk or Point of Sale (POS) terminal within the ClubReady system

Requirements:

1. Admin rights on the computer you are installing the scanner on

2. An availible USB port on the computer or powered USB Hub.

3. Access to the notepad application on your computer to test the scanner after install.

Step 1 - Verifying you have the correct scanner

Please verify the scanner matched the information listed below. If anything does not match

these instructions will not work for installing your scanner. This may also mean ClubReady will

not support or only be able to provide limited support for your scanner.

Manufacturer: Honeywell (formerly Metrologic)

Model Name: Voyager

Model Number: MS9520

Part Number: MK9520-32A38

Once you have verified all of the information above is correct, please continue to the next step.

How to install the Honeywell (formerly Metrologic) Voyager Scanner - 1

Table of Contents

Page 1 Manufacturer: Honeywell (formerly Metrologic) Model Name: Voyager Model Number: MS9520 Part Number: MK9520-32A38 Once you have verified all of the information above is correct, please continue to the next step. How to install the Honeywell (formerly Metrologic) Voyager Scanner - 1...
Page 2 3. Please wait a few minutes for the scanner to configure, most windows systems will display a notification in the lower-right corner of the screen near the time letting you know that it is configuring a device. How to install the Honeywell (formerly Metrologic) Voyager Scanner - 2...
Page 3 If you see the barcode number appear in notepad you have successfully configured the scanner for use within ClubReady. If you have any questions please contact us for assistance. How to install the Honeywell (formerly Metrologic) Voyager Scanner - 3...