Related Manuals for Honeywell Granit XP 1990i
Summary of Contents for Honeywell Granit XP 1990i
- Page 1 Granit™ XP 1990i Industrial Area-Imaging Scanner Quick Start Guide 1990-EN-QS-01 Rev A 5/20...
-
Page 2: Get Started
Agency Model: 1990i, 1990iSR, 1990iXR Note: Refer to your User Guide for information about cleaning your device. Get Started Turn off computer’s power before connecting the scanner, then power up the computer once the scanner is fully connected. Power Supply Assembly (if included) Note: The power supply must be ordered separately, if needed. -
Page 3: Connect The Scanner
Connect the Scanner When connecting the scanner, make sure the cable is pushed tightly into the scanner. Loosen the locking plate and slide it over the base of the cable connector to lock the cable in place. Tighten the screw. IP65/67 USB:... - Page 4 Keyboard Wedge: RS232 Serial Port:...
-
Page 5: Reading Techniques
Reading Techniques The view finder projects an aiming beam that should be cen- tered over the barcode, but it can be positioned in any direction for a good read. SR Models: XR Models: Standard Product Defaults The following barcode resets all standard product default set- tings. -
Page 6: Keyboard Country
USB PC Keyboard Scan the following code to program the scanner for a USB PC Keyboard. USB PC Keyboard Keyboard Country Scan the appropriate country code below to program the key- board layout for your country or language. By default, national character replacements are used for the following characters: #$@[\]^‘{|}~ Refer to the ISO 646 Character Replacements chart in your User Guide to view the character replacements for each... - Page 7 Germany/Austria Great Britain Italy Norway Spain Switzerland Note: For a complete list of country codes, see the User Guide for your product.
- Page 8 Trigger The following barcodes will allow you to use the scanner in Manual Trigger - Normal Mode (need to press the trigger to read) or Presentation mode (the scanner is activated when it “sees” a barcode). Manual Trigger - Normal (Default) Presentation Mode Streaming Presentation™...
-
Page 9: Add Code Id Prefix To All Symbologies
Add Tab Suffix Remove Suffix Add Code ID Prefix to all Symbologies Scan the following barcode if you wish to add a Code ID prefix to all symbologies at once. Add Code ID Prefix To All Symbologies (Temporary) Note: For a complete list of Code IDs, see the User Guide for your product. -
Page 10: User Documentation
Patents For patent information, see www.hsmpats.com. Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made. - Page 11 This document contains proprietary information that is pro- tected by copyright. All rights are reserved. No part of this docu- ment may be photocopied, reproduced, or translated into another language without the prior written consent of HII. Copyright2020 Honeywell International Inc. All rights reserved.