Complete The Initial Configuration - Cisco Firepower 2100 Getting Started Manual
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (232 pages) ,
- Manual (44 pages) ,
- Getting started manual (104 pages)
Table of Contents
Advertisement
Firepower Threat Defense Deployment with CDO
Before you begin
• Use a current version of Firefox or Chrome.
Procedure
Step 1
Enter the following URL in your browser.
• Inside (Ethernet 1/2)—https://192.168.1.1.
• (6.6 and later) Management—https://management_ip. The Management interface is a DHCP client, so
• (6.5 and earlier) Management—https://192.168.45.45. If you changed the Management IP address at
Step 2
Log in with the username admin, and thedefault password Admin123.
What to do next
• Run through the FDM setup wizard; see
Complete the Initial Configuration
Use the setup wizard when you first log into FDM to complete the initial configuration. After you complete
the setup wizard, you should have a functioning device with a few basic policies in place:
• An outside (Ethernet1/1) and an inside interface (Ethernet1/2).
• Security zones for the inside and outside interfaces.
• An access rule trusting all inside to outside traffic.
• An interface NAT rule that translates all inside to outside traffic to unique ports on the IP address of the
• A DHCP server running on the inside interface.
Procedure
Step 1
You are prompted to read and accept the End User License Agreement and change the admin password.
You must complete these steps to continue.
Step 2
Configure the following options for the outside and management interfaces and click Next.
Note
the IP address depends on your DHCP server. If you changed the Management IP address at the CLI
setup, then enter that address.
the CLI setup, then enter that address.
outside interface.
Your settings are deployed to the device when you click Next. The interface will be named "outside"
and it will be added to the "outside_zone" security zone. Ensure that your settings are correct.
Complete the Initial Configuration, on page
Cisco Firepower 2100 Getting Started Guide
Complete the Initial Configuration
15.
15
Hide quick links:
Advertisement
Chapters
Table of Contents
