Checking the Air Quality ..............21 Reserving Off Timer ..............23 Locking the Control Panel Buttons ..........24 Turning off the Screen ..............24 SMART FUNCTIONS ............. 25 LG ThinQ Application ..............25 Smart Diagnosis ................27 MAINTENANCE ............. 28 Cleaning the product exterior ............29 Cleaning the Filters ..............29 Replacing the filter ...............30...
SAFETY INSTRUCTIONS The following safety guidelines are intended to prevent unforeseen risks or damage from unsafe or incorrect operation of the appliance. The guidelines are separated into ‘WARNING’ and ‘CAUTION’ as described below. This symbol is displayed to indicate matters and operations that can cause risk.
Page 5
Operation • If the appliance is immersed in water, stop using it and contact the LG Electronics service centre. • If there is a gas leakage (isobutane, propane, LNG, etc.), do not touch the product or power plug and ventilate the area immediately.
Page 6
• If you detect any abnormal noise, odour or smoke, unplug the product immediately and contact an LG Electronics service centre. • Only an authorized repair person from LG Electronics service centre should disassemble, repair, or modify the appliance. • Do not use or store fire, combustibles (ether, benzene, alcohol, drugs, propane, butane, combustible spray, insecticide, air freshener, cosmetics, etc.) or flammable materials (candles,...
Page 7
CAUTION To reduce the risk of minor injury to persons, malfunction, or damage to the product or property when using this product, follow basic precautions, including the following: Installation • Do not tilt the appliance to pull or push it when transporting. •...
Page 8
• Do not let the moisture from the humidifier directly touch the appliance. • Do not use the appliance while it is not in upright position. • Do not use the appliance near objects vulnerable to heat. • Do not use detergents, cosmetics, chemicals, air fresheners, or disinfectants in the appliance.
Page 9
• For more detail information about disposal of your old batteries, please contact your city office, waste disposal service or the shop where you purchased the product. Also You can contact our LG Support Representative Call center from below Link https://www.lg.com/sa_en/support/contact/telephon...
UNPACKING Components Air purifier OWNER’S MANUAL Remote controller/Battery (CR2025, Owner’s Manual 1EA) • The exterior or components of the product may vary depending on the model.
Removing Packing Install the filter in the appliance. • Insert the filters so that the deodor- Materials izing care filter is placed at the inner side of the appliance and the aller- Unpack the appliance and remove any gen collection care filter is placed at packing tape or vinyl before using the the outer side of the appliance.
INSTALLATION Transporting or Moving the Installing the Appliance Appliance Install the appliance on a solid and level surface. Be sure to have two people transport the • If the installation surface is not even, appliance safely. vibration and noise may occur, and the •...
2. Fix the belt to the wall firmly using a screw from the provided product accessories. • The appliance should be installed and transported by a professional installation technician from LG, not arbitrarily by the customer. Belt...
OPERATION Appliance Overview Front View Left/Right wind controller PM1.0 (particles with a diameter between 1.0 and 2.5 micrometers) Use it to adjust the direction of wind sensor emission to the left and the right. It detects the concentration of Up/Down wind controller particles.
Page 15
Filter system CAUTION Prefilter • Do not throw the filter or use it for other It primarily minimizes large particles purposes. floating in the air. NOTE Allergen collection care filter • Keep the windows or doors closed while It minimizes PM1.0 and cigarette using the product.
Page 16
Control Panel Start/Stop Button Off Timer Button You can start or stop the operation. Allows you to use the Off Timer function. Mode Button • Pressing and holding it for 3 Use it to set the mode. seconds or more locks or unlocks the control panel buttons.
Page 17
Off Timer time set in the appliance Display the concentration of odour or the ‘On/Off Timer’ is set from the (colour) LG ThinQ application. Mode Display It is displayed when the Screen Off function is used. Air Flow Display...
Page 18
Remote controller CAUTION • Do not press a number of buttons simultaneously. Doing so may cause the appliance to become inoperable or malfunction. • Do not kick or step on the remote controller. Doing so may cause remote controller damage. •...
Operation starting Normal Mode Press the Start/Stop button to start the Purifies indoor air at a desired speed. operation. Smart Mode Adjusts wind direction and strength automatically according to the level of overall air quality. NOTE • You can adjust the direction by pressing the left/right Swing or up/down Swing button during Smart operation.
Adjusting the Fan Speed Adjusting the Wind Direction Adjust the air flow of the air purifier. Adjusting the Wind Direction to Press the Speed button during the operation. the Left/Right • Each time you press the button, the Operates the left/right wind controller and speed changes in the following order: blows air to the left or the right.
Checking the Air Quality The overall air quality can be checked through the status display panel. Understanding the Overall Air Quality The overall air quality is calculated based on the particles and odour (gas) concentrations and is categorized into 4 levels including green, yellow, orange or red depending on the contamination of the air.
Page 22
Knowing the Particles [Example of air status display] Concentration Display the size of Display the Display the dust particles and overall air You can check the particulate matter concentration of the concentration quality concentration by its particle size. odour in colour of particles in Press the Indicator button during the operation colour...
Reserving Off Timer NOTE • The overall air quality level is a result of Stops the operation automatically after the both PM concentration and the odour operation for the set time. level. Press the Off Timer button during the • Even two products placed in the same operation.
Locking the Control Panel Turning off the Screen Buttons Sets the screen to sleep mode. Press the Swing button for 3 seconds or You can lock the buttons on the Control more during the operation. Panel to prevent the appliance from Or, press the Display button on the control operating due to unforeseen reasons, such panel of the remote controller.
Allows you to set various options on the provider or refer to your wireless router appliance and in the application. manual. • LG ThinQ is not responsible for any NOTE network connection problems or any faults, malfunctions, or errors caused by network •...
Page 26
(WPA2 is recommended) and register the product again. Installing the LG ThinQ Application Search for the LG ThinQ application from the Google Play Store or Apple App Store on a smartphone. Follow instructions to download and install the application. Open Source Software Notice...
Use this feature to help you diagnose and • Launch the LG ThinQ application and solve problems with your appliance. select the Smart Diagnosis feature in the menu. Follow the instructions for audible...
Scheduled maintenance when it has reached the end of its lifespan even during the warranty period. Contact Cleaning Replacement Component the LG Electronics service centre or frequency frequency consumables shop on the LG Electronics 2 weeks site (www.lg.com). Clean it using a vacuum •...
Cleaning the product Cleaning the Filters exterior Open the air inlet of the appliance and separate the filter. Remove particles from the air inlet and Remove the particles from the filter the air outlet using a vacuum cleaner. using a vacuum cleaner or a soft brush. If the prefilter is severely contaminated, remove large particles first and wash it using running water.
Replacing the filter Open the air inlet of the appliance. Open the air inlet of the appliance and Open the sensor cover. replace the allergen collection care filter and the deodorizing care filter with new ones. • To avoid polluting the surroundings when replacing the filter, place a newspaper on the floor before you remove the filter.
Storage Close the sensor cover. If the appliance is not used for a long period of time, store it at a shaded and dry place. Operate the air purifier for one hour or more on a fine day. • This removes the moisture and prevents molds from building up inside the product.
Page 32
TROUBLESHOOTING Before Calling for Service Operation Symptoms Possible Causes & Solution Is the power plug unplugged from the outlet? The appliance does not operate. • Plug it into the outlet properly. Is the light of air quality turned on red or orange? •...
Page 33
LG ThinQ app and your appliance. the appliance and the • The difference in the values could be caused by the difference in LG ThinQ app. updated time between the LG ThinQ app and the appliance. Performance Symptoms Possible Causes & Solution Is the indoor contamination severe? •...
Page 34
• Find the Wi-Fi network connected to your smartphone and remove it, then register your appliance on LG ThinQ. Mobile data for your smartphone is turned on. • Turn off the Mobile data of your smartphone and register the appliance using the Wi-Fi network.
Page 35
Height Depth Width Appearance and specifications may vary without notice to improve the quality of the appliance. Model AG16GB Series Power AC 220~240V 50/60 Hz Exterior dimensions (Depth x 320 mm x 590 mm x 1,840 mm Width x Height)
Page 36
Name: (Signature) ※ LG Electronics and the installation technician use the personal information of the customer stated in this letter of agreement only for the purpose of fact checking and the personal information will never be used for other purposes.