Cisco Catalyst Blade Switch 3130 Hardware Installation Manual page 46
For dell
Hide thumbs
Also See for Catalyst Blade Switch 3130:
- Reference manual (984 pages) ,
- Installation manual (29 pages)
Table of Contents
Advertisement
Installing Devices in the 10-Gigabit Ethernet Slots
Figure 2-14
3
4
3
4
3
4
3
4
1
2
Removing an SFP Module
To remove an SFP module from a module slot, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 1
Disconnect the cable from the SFP module. For reattachment, note which cable connector plug is send
Step 2
(TX) and which is receive (RX).
Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 3
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
Step 4
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch.
Grasp the SFP module, and carefully remove it from the module slot.
Step 5
Place the removed SFP module in an antistatic bag or other protective environment.
Step 6
Category 5e and Category 6 cables can store high levels of static electricity. Always ground the cables
Caution
to a suitable and safe earth ground before connecting them to the switch or other devices.
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
2-26
Converter Module with SFP Modules Installed
2 2
2 1
1
X 2 -1
2
2 4
2 3
1
X 2 -2
2
W S -C B
S 3 1 3 0 X
-S
Converter modules
SFP modules
3
Send (TX) optical bore
4
Receive (RX) optical bore
Chapter 2
Switch Installation
OL-13269-01
Advertisement
Table of Contents
