Table of Contents
Advertisement
Periodic maintenance and adjustment
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure to turn
the main switch off, then con-
nect the positive lead before
connecting the negative lead.
[ECA16842]
4. When installing the battery, make
sure the positive battery lead is
routed through the hole in the bat-
tery band and that both battery
leads are properly connected to
the battery terminals.
6
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
5. Place the battery cover in the orig-
inal position, and then install the
bolts.
6. Install the diagnostic connector by
pushing it downward.
7. Install the seat holder by installing
the bolts, and then tighten the
bolts to the specified torque.
Tightening torque:
Seat holder bolts:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
ECA16531
6-31
Replacing the fuses
The main fuse and the fuse boxes are
located under the seat.
To access the fuses
1. Remove the seat. (See page 3-18.)
2. Remove the seat holder by remov-
ing the bolts.
2
1
ZAUM1377
1. Seat holder
2. Bolt
3. Remove the diagnostic connector
by pulling it upward.
4. Remove the battery cover by re-
moving the bolts.
EAUM3672
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
