Advertisement
Quick Links
Before you begin installation, read these instructions completely and carefully.
Observe all governing codes and ordinances as they may apply.
Leave these instructions with the owner.
IMPORTANT SAFETY NOTICE
!
is to be installed only by a licensed and trained industry professional. The manufacturer will not
assume liability for unqualified installers or failure to follow these instructions.
WARNING
!
For personal safety, disconnect system power before installing this accessory.
During installation, if ground wires, screws, straps, clips, or other means of attaching grounding
components are removed, they must be returned to their original positions and fastened securely.
Model: UAWB46A
Parts Included:
• Wind baffle (2 parts)
• 8 stainless self-tapping screws
• 4 screw covers
• This instruction sheet
Step 1:
Remove top screws from grille, slide the wind
baffle behind and replace the factory screws.
1
To avoid personal injury or property damage, this accessory
Step 2:
On some models, the grille screws can be used
in the same manner as the top. Use the sup-
plied screws if needed.
Installation Instructions
Wind Baffle
31-5000502 Rev. 0 04-20 GEA
Advertisement
Summary of Contents for Haier GE UAWB46A
- Page 1 Installation Instructions Wind Baffle Before you begin installation, read these instructions completely and carefully. Observe all governing codes and ordinances as they may apply. Leave these instructions with the owner. IMPORTANT SAFETY NOTICE To avoid personal injury or property damage, this accessory is to be installed only by a licensed and trained industry professional.
- Page 2 Installation Instructions Wind Baffle Step 3: Drive 3 screws through the front of the wind baffle where the two pieces overlap. This will eliminate any vibration rattle during operation. Cover the ends of the screws with the supplied caps to prevent any injury when reaching down between the baffle and the grille. 31-5000502 Rev.