Summary of Contents for Epson S5U1C88816P
- Page 1 MF1337 - 02a CMOS 8 - BIT SINGLE CHIP MICROCOMPUTER S5U1C88816P Manual (Peripheral Circuit Board for S1C88816/8F360)
- Page 2 No part of this material may be reproduced or duplicated in any form or by any means without the written permission of Seiko Epson. Seiko Epson reserves the right to make changes to this material without notice. Seiko Epson does not assume any...
- Page 3 Configuration of product number Devices 88104 0A01 Packing specifications 00 : Besides tape & reel 0A : TCP BL 2 directions 0B : Tape & reel BACK 0C : TCP BR 2 directions 0D : TCP BT 2 directions 0E : TCP BD 2 directions 0F : Tape &...
-
Page 5: Table Of Contents
In this manual we will provide explanations covering such areas as the installation of the S1C88816/8F360 Peripheral Circuit Board (S5U1C88816P) that provides the S1C88816/8F360 emulation functions to the debugging tool ICE (S5U1C88000H5) for the 8-bit single chip microcomputer S1C88 Family, and the operating test procedure. -
Page 7: Introduction
RESET switch Fig. 1.3.1 S5U1C88816P external drawing Note: Keep the JP switch on the S5U1C88816P board as it was set prior to factory shipment. In no case should you remove it or change EPSON... -
Page 8: Installation Into The Ice (S5U1C88000H5)
2 INSTALLATION INTO THE ICE (S5U1C88000H5) INSTALLATION INTO THE ICE (S5U1C88000H5) Insert the S5U1C88816P along by the upper guide rail of the ICE, until it touches the edge of the S5U1C88816P. I C E 8 8 ∗ The name 'ICE88UR' on the development tool is the old name of the product. -
Page 9: Precautions
3 PRECAUTIONS 3 PRECAUTIONS Take the following precautions when using the S5U1C88816P: 3.1 Precaution for Operation 3.2 Differences from Actual IC (1) Turn the power of all equipment off before Caution is called for due to the following function connecting or disconnecting cables. - Page 10 IC. be sure to switch OSC3 oscillation OFF with separate instructions. Using a single instruction • When the S5U1C88816P is used with the ICE, to process simultaneously can cause a malfunc- accessing unused addresses can be detected tion of the CPU.
-
Page 11: Names And Functions Of Parts
4 NAMES AND FUNCTIONS OF PARTS NAMES AND FUNCTIONS OF PARTS This section describes the names and functions of the parts of the S5U1C88816P. VSVD RESET VDC1 OSCC SVDON LCDC LCD5.5V MONITOR I/O#1 VDC0 VDC2 MODE HVLD LCD4.5V EXLCD I/O#3... -
Page 12: Connection To Target System
5 CONNECTION TO TARGET SYSTEM 5 CONNECTION TO TARGET SYSTEM This section describes how to connect the S5U1C88816P to the target system. Note: Turn the power of all equipment off before connecting or disconnecting cables. (1) The I/O #1, I/O #2 and I/O #3 connectors are... - Page 13 5 CONNECTION TO TARGET SYSTEM (3) I/O connector pin assignment for S1C88816 Table 5.1 lists the I/O connector pin assignment when using the S5U1C88816P for the S1C88816. Table 5.1 Pin assignment of I/O connector (for S1C88816) I/O#1 connector I/O#2 connector...
- Page 14 5 CONNECTION TO TARGET SYSTEM (4) I/O connector pin assignment for S1C8F360 Table 5.2 lists the I/O connector pin assignment when using the S5U1C88816P for the S1C8F360. Table 5.2 Pin assignment of I/O connector (for S1C8F360) I/O#1 connector I/O#2 connector...
-
Page 15: Operation Check
(2) Check using the VDC0–2, OSCC, MODE, SVDON, HVLD, LCDC, LCD4.5V, LCD5.5V and EXLCD LEDs on the S5U1C88816P. If the below light statuses are verified following system reset, it is normal. The cycle count indicates a 1 second interval and the light status of the below LED changes every second. -
Page 16: Product Specifications
7 PRODUCT SPECIFICATIONS 7 PRODUCT SPECIFICATIONS The components specifications of the S5U1C88816P are listed below. S5U1C88816P Monitor terminal cable Dimensions (mm): 247.5 (W) × 165 (D) × 44.6 (H) S5U1C88816P connector: Weight: Approx. 460 g (board) 3M 7610-5002SC or equivalent Power supply: DC 5 V ±... - Page 17 Central Phone: +852-2585-4600 Fax: +852-2827-4346 101 Virginia Street, Suite 290 Telex: 65542 EPSCO HX Crystal Lake, IL 60014, U.S.A. EPSON TAIWAN TECHNOLOGY & TRADING LTD. Phone: +1-815-455-7630 Fax: +1-815-455-7633 10F, No. 287, Nanking East Road, Sec. 3 Northeast Taipei 301 Edgewater Place, Suite 120...
- Page 18 S5U1C88816P Manual (Peripheral Circuit Board for S1C88816/8F360) ELECTRONIC DEVICES MARKETING DIVISION EPSON Electronic Devices Website http://www.epsondevice.com First issue July, 2000 Printed April, 2001 in Japan...