Cable The Device - Cisco Firepower 2100 Series Getting Started Manual
Hide thumbs
Also See for Firepower 2100 Series:
- Hardware installation manual (92 pages) ,
- Manual (12 pages) ,
- Deployment manual (8 pages)
Table of Contents
Advertisement
Cable the Device
Cable the Device
Manage the Firepower 2100 on the Management 1/1 interface. You can use the same management computer
for FXOS and ASA. The default configuration also configures Ethernet1/1 as outside.
Procedure
Step 1
Connect your management computer directly to Management 1/1 (labeled MGMT), or connect Management
1/1 to your management network.
Make sure your management computer is on the management network, because only clients on that network
can access the ASA or FXOS. Management 1/1 has a default FXOS IP address (192.168.45.45) and ASA
default IP address (192.168.45.1). FXOS also runs a DHCP server to provide IP addresses to clients (including
the management computer), so make sure these settings do not conflict with any existing management network
settings (see
You can later configure FXOS and ASA management access from data interfaces. For FXOS access, see
(Optional) Configure Management Access for FXOS on Data Interfaces, on page
the
ASA general operations configuration
Step 2
Connect your management computer to the console port.
You need to access the ASA CLI to change from Appliance mode to Platform mode. The Firepower 2100
ships with a DB-9 to RJ-45 serial cable, so you will need a third party serial-to-USB cable to make the
connection. Be sure to install any necessary USB serial drivers for your operating system.
Step 3
Connect the outside network to the Ethernet1/1 interface (labeled WAN).
For Smart Software Licensing, the ASA needs internet access so that it can access the License Authority.
Cisco Firepower 2100 Getting Started Guide
76
Firepower 2100 Platform Mode Default Configuration, on page
guide.
ASA Deployment in Platform Mode
74).
90. For ASA access, see
Hide quick links:
Advertisement
Chapters
Table of Contents
