Advertisement
Quick Links
Advertisement
Related Manuals for Toshiba RSAP
Summary of Contents for Toshiba RSAP
- Page 1 TOSHIBA International Corp REMOTE STATUS ALARM PANEL RSAP INSTALLATION/INSTRUCTION MANUAL...
- Page 2 Table of Contents Physical Characteristics…………………………………………….… 3 Installation Instructions……………………………………………….. 3 Operating Instructions…………………………………………………. 4 Remote Monitor Closed (Figure 1.0)………………………………… 5 Remote Monitor Closed Hardwire (Figure 1.1)…………………….. 6 Terminal Block Description (Figure 2.0)……………………………. 7 Terminal Block Description (Figure 2.1)…………………………..…8 Remote Monitor Open (Figure 3.0)…………………………………... 9 Remote Monitor Open Hardwired (Figure 3.1)…………………...
- Page 3 /or national electric codes. 4. Connect the conduit to the RSAP by punching the appropriately sized hole in a convenient location. 5. Referring to Figure 2.0, 3.0 and the corresponding UPS wiring diagram, connect the seven (7) pairs of twisted wire from the RSAP to the customer accessible alarm contact terminal bar in the UPS module.
- Page 4 Operating Instructions ALARM SILENCE pushbutton is used to silence the alarm. MONITOR RESET pushbutton is used to reset the RSAP UPS FAULT alarm. The monitor will alarm again if the alarm condition is still present following the RESET. Monitor TEST pushbutton is used to check the operation of all LED’s and the audible alarm. All LED’s that are illuminated will go off and all lights that are off will illuminate.
- Page 8 TB 1 1 AC Input L1 (option) 2 AC Input L2 (option) 3 BYPASS 4 BYPASS 5 BYPASS 6 BYPASS COMMON 7 INVERTER 8 INVERTER COMMON 9 ON BATTERIES 10 ON BATTERY COMMON 11 RECTIFIER 12 RECTIFIER COMMON 13 UPS FAILURE 14 UPS COMMON 15 LOW BATTERY 16 LOW BATTERY COMMON...