Table of Contents
Advertisement
11. Screw in the two screws and replace the memory module cover.
Screws
12. Insert the tabs on the front of the keyboard into the corresponding
notches on the computer and place the keyboard down.
When seating the keyboard, be sure to connect the circuit board if the
keyboard ribbon cable was pulled out while you were removing the
keyboard.
13. Replace the keyboard and secure it using the two screws.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure no foreign matter can be found
inside the computer.
Tabs
14. Set the keyboard brace into its groove and hold down to secure the
latches.
15. Install the battery pack. Refer to
Chapter 6, Power and Power-Up Modes, for details.
16. Turn your computer over.
17. Turn the computer on and make sure the added memory is recognized
- to confirmed it, Start -> Control Panel -> System and Maintenance -
> System icon.
User's Manual
Figure 3-12 Seating the memory module cover
Figure 3-13 Replace the keyboard
Hardware, Utilities and Options
Replacing the battery pack
Memory module
cover
Keyboard
Screws
section in
3-27
Advertisement
Table of Contents
