Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Beko WMB 71031
Summary of Contents for Beko WMB 71031
- Page 1 Washing Machine WMB 71031...
-
Page 2: Installation
1 Warnings persons (including children) with reduced physical, sensory or mental capabilities, General Safety or lack of experience and knowledge, • Never place your machine on a carpet unless they have been given supervision or covered floor. Otherwise, lack of airflow from instruction concerning use of the appliance by below of your machine may cause electrical a person responsible for their safety. parts to overheat. This may cause problems Safety instructions with your washing machine. • This appliance must be connected to an • If the power cable or mains plug is damaged earthed outlet protected by a fuse of suitable you must call Authorized Service for repair. capacity. • Fit the drain hose into the discharge housing • The supply and draining hoses must always securely to prevent any water leakage and be securely fastened and remain in an to allow machine to take in and discharge undamaged state. water as required. It is very important that the • Fit the draining hose to a washbasin or water intake and drain hoses are not folded, bathtub securely before starting up your squeezed, or broken when the appliance machine. There may be a risk of being is pushed into place after it is installed or scalded due to high washing temperatures! cleaned. -
Page 3: Adjusting The Feet
• The end of the drain hose must be directly connected to the wastewater drain or to the washbasin. • The hose should be attached to a height of at least 40 cm, and 100 cm at most. Keep the transportation safety bolts in a safe • In case the hose is elevated after laying it on place to reuse when the washing machine the floor level or close to the ground (less than needs to be moved again in the future. 40 cm above the ground), water discharge Never move the appliance without the becomes more difficult and the laundry may transportation safety bolts properly fixed in come out wet. place! Adjusting the feet Do not use any tools to loosen the lock nuts. Otherwise, they can be damaged. 1. Manually (by hand) loosen the lock nuts on the feet. 2. Adjust them until the machine stands level and firmly. 3. Important: Tighten all lock nuts up again. • The hose should be pushed into the drainage Connecting to the water supply. for more than 15 cm. If it is too long you may Important: have it shortened. -
Page 4: Initial Preparations For Washing
3 Initial preparations for washing detergent should be put into the pre-wash compartment (Compartment no. 1). Preparing clothes for washing Detergent quantity Laundry items with metal attachments such as, The amount of washing detergent to be used bras, belt buckles and metal buttons will damage depends on the amount of laundry, the degree of the machine. Remove metal attachments or soiling and water hardness. place the items in a clothing bag, pillow case, or • Do not use amounts exceeding the quantities something similar. recommended on the package to avoid • Sort the laundry according to type of fabric, problems of excessive foam, poor rinsing, color, and degree of soiling and permissible financial savings and finally, environmental water temperature. Always follow the advice protection. on the garment labels. • Never exceed the (> max <) level marking; • Place small items like infants’ socks and nylon otherwise, the softener will be wasted without stockings, etc. in a laundry bag, pillow case being used. or something similar. This will also save your •... -
Page 5: Selecting A Program And Operating Your Machine
4 Selecting a Program and Operating Your Machine Control Panel 1 - Program selection knob (Uppermost position 5 - Start/Pause button On/Off) 6 - Auxiliary function keys 2 - Display 7 - Spin speed adjustment button 3 - Time delaying button 8 - Temperature adjustment button 4 - Program follow-up indicator Programs are limited with the highest spin Turning the machine on speed appropriate for that particular type of Plug in your machine. Turn the tap on completely. cloth. Check if the hoses are connected tightly. Place Sort the laundry according to type of fabric, the laundry in the machine. Add detergent and color, degree of soiling and permissible water softener. "Turn the program selection knob to the temperature when choosing a program. program position you wish to run." Always select the lowest required temperature. Higher temperature means Program selection higher power consumption. For further program details, see, "Program Select the appropriate program from the program Selection Table"... -
Page 6: Additional Programs
recommended. spin speed. • Woollens If you only want to drain the water without spinning You can wash your machine-washable woolen your laundry, select “Spin and Pump” program, garments on this program. Wash by selecting the and then select no spin function with spin speed proper temperature according to the labels of your selection button. Press Start/Pause button. clothes. It is recommended to use appropriate Use a lower spin speed for delicate laundries. detergents for woolens. Spin Speed selection Additional programs Whenever a new program is selected, the For special cases, there are also extra programs maximum spin speed of the selected program is available displayed on the spin speed indicator. Additional programs may differ according to To decrease the spin speed, press the “Spin” the model of your machine. button. Spin speed decreases gradually. Use No • Cotton Economic Spin option in order to drain the water without You may wash your laundry to be washed in spinning at the end of the program. cottons program in longer periods which ensure If the spin settings contain the rinse hold option: very good washing performance. If you are not going to unload your clothes Cottons economy program consumes less immediately after the cycle, you may use rinse hold energy compared to other cottons programs. -
Page 7: Program Selection And Consumption Table
Program selection and consumption table Selectable Programme temperature range °C Cottons 2.30 1600 • • • • • • Cold-90 Cottons 1.54 1600 • • • • • • Cold-90 Cottons 0.85 1600 • • • • • • Cold-90 Cotton Economic 60** 1.19 1600 •... -
Page 8: Time Display
Auxiliary functions machine. Press "Start/Pause" button after this process if you want to drain the water without Auxiliary Function Selection Buttons spinning. Program resumes. Your machine drains Select the required auxiliary functions before the water and program completes. starting the program. Furthermore, you may also select or cancel auxiliary functions that are suitable If you want to spin your laundry that you left in to the running program without pressing the "Start/ water: Pause" button. To select or cancel the auxiliary - Adjust the spin speed. functions, the machine must be at any prior - Press Start/Pause button stage than the auxiliary function to be selected Program resumes. Your machine drains the water, or cancelled. If the auxiliary function cannot be spins the laundry and program completes. selected or cancelled, light of the relevant auxiliary In case of selecting the auxiliary function for function will blink 3 times to warn the user. soaking, your laundry will be kept in detergent Some combinations cannot be selected water before the washing process starts. Hence, together. Ex.: Pre-wash and Quick Wash. stains that ingrained into the laundry can be Warning light of the selected auxiliary function removed better. will light up. • Pet hair removal Auxiliary function selection This function helps you to remove the pet hairs If an auxiliary function that is not compatible with that remain on your clothes. -
Page 9: Starting The Program
1-hour increments. met, the "Door" light will remain off. 2. If you wish to shorten the time delay, keep on Changing the speed and temperature settings pressing the time delay button until the time for auxiliary functions delay you would like to set appears on the Auxiliary functions can be cancelled or selected, or screen. the spin speed and temperature settings can be Canceling the time delay changed in accordance with the step the program If you want to cancel the time delay countdown is in. If the change can not be made, relevant light and start the program: will flash for 3 times. 1. Set the Time Delay to zero or turn the Adding/removing laundry in pause mode Program selection knob to any program. If the "Door" light flashes while the machine is in Thus, the time delay will be cancelled. The “ pause mode, it means that the conditions (low ” (End/Cancel) light flashes continuously. water level, etc.) to open the door have been Then, select the program you wish to run met and the period of approx. 1 or 2 minutes to... -
Page 10: Ending The Program Through Canceling
5 Maintenance and cleaning the lights on the auxiliary function buttons 1 and 2 are flashing during 3-second press Detergent Drawer and hold process, C03, C02 and C01 Remove any powder residue buildup in the drawer. labels will be displayed respectively. Then, To do this; the "COF" label will be displayed to show 1. Press the dotted point on the siphon in the that the child-proof lock mode has been softener compartment and pull towards you deactivated. until the compartment is removed from the b) In addition to the above method, child-proof machine. lock can also be deactivated by turning the program selection knob to "On/Off" position and selecting another program when no program is running. Child-proof lock will not be deactivated in case of power failures or when the machine is unplugged. To deactivate the child-proof lock, press the 1st and 2nd auxiliary function buttons for 3 sec. If more than a normal amount of water Ending the program through canceling and softener mixture starts to gather in the When another program is selected instead softener compartment, the siphon must be of a running program by turning the program cleaned. -
Page 11: Draining Any Remaining Water And Cleaning The Pump Filter
Draining any remaining water and • Pull out the pump outlet hose from its housing. cleaning the pump filter • Place a large container at the end of the Your product is equipped with a filter system which hose. Drain the water off into the container ensures a cleaner water discharge that extends by pulling out the plug at the end of the hose. pump life by preventing solid items such as If the amount of water to be drained off is buttons, coins and fabric fibers from clogging the greater than the volume of the container, pump propeller during discharge of the washing replace the plug, pour the water out, then water. resume the draining process. • If your machine fails to drain the water, the • After draining process is completed, replace pump filter may be clogged. You may have the plug into the end of the hose and fit the to clean it every 2 years or whenever it is hose back into its place. plugged. Water must be drained off to clean If your product is not supplied with an emergency the pump filter. drain hose, do the following as shown in the figure In addition, water may have to be drained off below: completely in the following cases: • before transporting the machine (e.g. when moving house) -
Page 12: Solution Suggestions For Problems
6 Solution suggestions for problems Cause Explanation / Suggestion Program cannot be started or selected. • Machine may have switched to self • When another program is selected instead protection mode due to an infrastructure of a running program by turning the program problem (such as line voltage, water selection knob, the previous program is pressure, etc.). cancelled. (see, Canceling a Program) There is water coming from the bottom of the machine. • Be sure the seals of the water inlet hoses are securely fitted. • There might be problems with hoses or the • Tightly attach the drain hose to the tap. pump filter. • Make sure that the pump filter is completely closed. Machine stopped shortly after the program started. • Machine can stop temporarily due to low • It will resume operating when the voltage is voltage. back to the normal level. It continuously spins. Remaining time does not count down. (For models with a display) • The automatic spin correction system might have been activated due to the unbalanced distribution of the laundry in the drum. -
Page 13: Specifications
7 Specifications Models WMB 71031 Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net Weight (±4 kg) 230 V / 50Hz Electricity (V/Hz.) Total Current (A) 2200 Total Power (W) 1000 Spinning cycle (rpm max.) Specifications of this appliance may change without notice to improve the quality of the product. Figures in this manual are schematic and may not match your product exactly. Values stated on the machine labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant standards. Depending on operational and environmental conditions of the appliance, values may vary. This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points clos- est to your home. We thank you doing your part to protect the environment. Dark wash Dark wash Synthetics Cottons Pre-wash Main Rinse Wash Spin Delicate Pet hair Door Ready (Darkcare)