Advertisement
Quick Links
Replacement Hose Kit
Three-Wheel Drive Kit 04474 for Greensmaster 3150
Model No. 119–3564
Installation
1
Draining the Hydraulic
Reservoir
No Parts Required
Procedure
1. Park the machine on a level surface, lower the cutting
units, set the parking brake, turn the engine off and
remove the key from the ignition switch
2. Drain the hydraulic oil from the reservoir into a large
clean container. Refer to the Operator's Manual for
the draining procedure.
Important: Take care not to contaminate oil if
you are going to reuse it. A very small amount
of dirt or debris can severely damage hydraulic
system.
2
Installing the Hoses
Parts needed for this procedure:
1
Hose (119–3557)
1
Hose (119–3558)
Procedure
1. Disconnect and remove the (2) hydraulic hoses
secured to the rear wheel motor fittings and the
bulkhead fittings (Figure 1).
2. Loosely install the shorter hydraulic hose (119–3557)
to the pump hose assembly (lower bulkhead) and to
the upper wheel motor fitting (Figure 1).
© 2010—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
1. Hydraulic hose, shorter
Note: Before installing any hydraulic fittings or
hoses, make sure the correct O-rings are in position
and lubricated with hydraulic oil.
3. Loosely install the longer hydraulic hose (119–3558)
to the hydraulic hard line (upper bulkhead) and to
the bottom wheel motor fitting (Figure 1).
4. Adjust the hoses and fittings so the hoses are not
twisted or kinked. Make sure they are positioned as
shown in Figure 1.
Note: The hoses must not contact the tire or the
rim.
3
Completing the Installation
No Parts Required
Procedure
1. Turn the steering fork fully side to side to check for
proper hose flex and position. With the steering
wheel in full right turn, it may be necessary to rotate
Register at www.Toro.com.
Form No. 3366-361 Rev A
Installation Instructions
1 2
Figure 1
2. Hydraulic hose, longer
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
g014383
Advertisement
Summary of Contents for Toro 04474
- Page 1 Form No. 3366-361 Rev A Replacement Hose Kit Three-Wheel Drive Kit 04474 for Greensmaster 3150 Model No. 119–3564 Installation Instructions Installation Draining the Hydraulic Reservoir No Parts Required Procedure 1. Park the machine on a level surface, lower the cutting...
- Page 2 the rear hydrostat hose fitting slightly downward to gain clearance with the rear wheel motor. 2. Tighten all fittings securely. Use a back up wrench on the fittings when appropriate. 3. Secure the hoses with nylon tie straps, if applicable. Important: Check to make sure the hoses are secured away from any hot, sharp or moving components.