Attaching The Rps Connector Cover - Cisco Catalyst 2960 Installation Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Chapter 1
Switch Installation
Attaching the RPS Connector Cover
The Catalyst 2960S-F48FPS-L, 2960S-F48LPS-L, 2960S-F24PS-L, 2960S-F48TS-L, 2960S-F24TS-L,
Note
2960S-F48TS-S, and 2960S-F24TS-S switches do not have an RPS connector and a cover is not needed.
These models do not support RPS.
If you are not using an RPS with your switch, use the two Phillips pan-head screws to attach the RPS
connector cover to the back of the switch
If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch.
Warning
Statement 265
Figure 1-15
1
2
OL-19732-04
Attaching the RPS Connector Cover
1
2
Phillips pan-head screws (48-0482-01) 3
RPS connector cover
(Figure
1-15).
RA TIN G
10 0-2 40 ~
12 -6A , 50
-60 Hz
3
RPS connector
Catalyst 2960-S Switch Hardware Installation Guide
Installing the Switch
1-15
- Quick Links:
- Switch Installation
Hide quick links:
Advertisement
Table of Contents
