Advertisement
Preparing for Installation
•
•
•
•
•
•
•
Safety Recommendations and Warnings
Review the safety warnings listed in Regulatory Compliance and Safety Information for the Cisco 5100
Enterprise Network Compute System before installing, configuring, or maintaining the device.
Please read the following safety guidelines before you install this product:
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning
Read the installation instructions before you connect the system to its power source. Statement 1004
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Safety Recommendations and Warnings, on page 1
Safety with Electricity, on page 2
Site Requirements, on page 3
Mounting Requirements, on page 4
Power Guidelines and Requirements, on page 5
Network Cabling Specification, on page 5
Required Tools and Equipment, on page 5
Preparing for Installation
1
Advertisement
Table of Contents
Related Manuals for Cisco 5100
Summary of Contents for Cisco 5100
-
Page 1: Table Of Contents
Required Tools and Equipment, on page 5 Safety Recommendations and Warnings Review the safety warnings listed in Regulatory Compliance and Safety Information for the Cisco 5100 Enterprise Network Compute System before installing, configuring, or maintaining the device. Please read the following safety guidelines before you install this product: Warning This warning symbol means danger. -
Page 2: Safety With Electricity
Preparing for Installation Safety with Electricity Always follow these electrostatic discharge (ESD) prevention procedures when removing and replacing modules: • Ensure that the chassis is electrically connected to ground. • Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. Connect the clip to an unpainted surface of the chassis frame to channel unwanted ESD voltages safely to ground. -
Page 3: Site Requirements
Preparing for Installation Site Requirements • Never touch uninsulated telephone wires or terminals unless the telephone line is disconnected at the network interface. • Use caution when installing or modifying telephone lines. • Remove power cables from all installed power supplies before opening the chassis. Always follow these electrostatic discharge (ESD) prevention procedures when removing and replacing modules: •... -
Page 4: Mounting Requirements
To place the system in a proper location, it is necessary to know the dimensions of the device's chassis. The Cisco 5100 ENCS can be placed on a desktop or installed in a rack. The mounting ears for the device are designed for #12-24 UNC screws. -
Page 5: Power Guidelines And Requirements
Preparing for Installation Power Guidelines and Requirements • Enclosed racks must have adequate ventilation. Ensure that the rack is not congested, because each device generates heat. An enclosed rack should have louvered sides and a fan to provide cooling air. Heat generated by equipment near the bottom of the rack can be drawn upward into the intake ports of the equipment above it. - Page 6 Preparing for Installation Required Tools and Equipment Preparing for Installation...