Table of Contents
Advertisement
Chapter 1
Overview
For E3 (75-ohm) connections, you must have ferrite beads on the 75-ohm coaxial cable and EMI
Note
decoupling clips on the receive end of the cable (see
certification standards for emission control is required (EN55022/CISPR22 Class B for radiated
emission levels).
Figure 1-5
You can test the DTE-to-DCE cable connection by using the loopback dte command. See the
loopback Commands" section on page 4-29
Management Information Base
Management Information Base (MIB) attributes are readable and writable across the ILMI through use
of SNMP.
The one-port PA-E3 supports MIB-II (RFC 1213) and the E3 interface MIB (RFC 1407).
The two-port PA-2E3 supports MIB-II (RFC 1213) and the E3 interface MIB (RFC 1407).
Port Adapter Slot Locations on the Supported Platforms
The following sections provide port adapter slot locations and related information:
•
•
•
•
•
•
•
•
•
•
OL-3502-04
PA-E3 Cables
EMI decoupler clip
Ferrite beads
Catalyst RSM/VIP2 Slot Numbering, page 1-6
Catalyst 6000 Family FlexWAN Module Slot Numbering, page 1-7
Cisco 7100 Series Routers Slot Numbering, page 1-8
Cisco 7200 Series Routers and Cisco 7200 VXR Routers Slot Numbering, page 1-9
Cisco uBR7200 Series Router Slot Numbering, page 1-10
Cisco 7201 Router Slot Numbering, page 1-11
Cisco 7301 Router Slot Numbering, page 1-11
Cisco 7304 PCI Port Adapter Carrier Card Slot Numbering, page 1-12
Cisco 7401ASR Router Slot Numbering, page 1-13
Cisco 7000 Series Routers and Cisco 7500 Series Routers VIP Slot Numbering, page 1-13
Figure
1-5) if compliance with European
for more information.
PA-E3 Serial Port Adapter Installation and Configuration
Management Information Base
"Using
1-5
Advertisement
Table of Contents
