Table of Contents
Advertisement
Checking the Configuration
Write the new configuration to NVRAM as follows:
Step 5
Router# copy running-config startup-config
[OK]
Router#
This completes the procedure for configuring controlled-carrier mode on a PA-T4+ interface. For
additional information on configuring half-duplex operation on low-speed serial interfaces, refer to the
chapter "Configuring Interfaces" of the Configuration Fundamentals Configuration Guide on
Cisco.com.
Note
To configure PA-4T+ interfaces for Binary Synchronous (Bisync) operation in Cisco 7200 series series
routers, refer to the "Block Serial Tunneling (BSTUN)" section of the "Configuring Serial Tunnel
(STUN) and Block Serial Tunnel (BSTUN)" chapter of the Bridging and IBM Networking Configuration
Guide on Cisco.com.
Checking the Configuration
After configuring the new interface, use the show commands to display the status of the new interface
or all interfaces and the ping and loopback commands to check connectivity.
This section contains the following subsections:
•
•
•
Using show Commands to Verify the New Interface Status
Table 5-8
and operating correctly and that the PA-4T+ appears in them correctly. Sample displays of the output of
selected show commands appear in the sections that follow. For complete command descriptions and
examples, refer to the publications listed in the
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
PA-4T+ Synchronous Serial Port Adapter Installation and Configuration
5-18
Using show Commands to Verify the New Interface Status, page 5-18
Using the ping Command to Verify Network Connectivity, page 5-33
Using loopback Commands, page 5-34
demonstrates how you can use the show commands to verify that new interfaces are configured
Chapter 5
"Related Documentation" section on page
Configuring the PA-4T+ Interfaces
viii.
OL-3561-04
Advertisement
Table of Contents
