Table of Contents
Advertisement
Setup Menu
Meter Setup
Ethernet Port
Enable Setup
Communications
Setup
Display Setup
Date/Time/Clock
Setup
Alarm Setup
Language Setup
Time of Use
Setup
Resets
Password Setup
Meter setup using your display
106
Volts Mode
Volts Mode
PT/CT Setup
PT Primary
Voltage Polarity Setup
Va Polarity
Current Polarity Setup
Ia Polarity
Nominal
Nominal Values
Voltage
Ethernet Port Enable
Enable/Disable
Setup
IPv4 Assignment Mode
Setup
Stored IPv4 Address
Stored IPv4
Setup
Address
IPv6 Link Local Address
IPv6 Assignment Mode
Setup
Acquired IPv6 Global
Address
Ethernet Device Name
DNS Setup
COM1 Setup
Protocol
COM4 Setup
Protocol
NTP Address
SMTP Address
Backlight
Screen Setup
Timeout
Label & Symbol Setup
Phase Label
Numeric Format Setup
Digit Grouping
Date & Time Setup
Time Format
Clock Setup
Clock Source
Alarm Setup
Enable/Disable
Language Setup
TOU Active Rates
TOU Season
Select for
Resets
Reset
Password Setup
Navigate to Setup screens and enter parameters to configure your meter.
Your meter's default display password is 0 (zero).
NOTE: Your meter locks you out of display configuration after you have
exceeded the maximum number of attempts to enter a password.
The following example shows how to use the navigation buttons to select
parameters, enter numeric information or select parameter values from lists.
NOTE: Your display may appear differently than those shown, depending on
your meter's power system and display and localization settings.
Example: setting volts mode and PT/CT ratios
Use the display navigation buttons to set your meter's volts mode and PT ratios.
NOTE: Potential transformers (PT) are also known as voltage transformers
(VT).
1. Press
to display the menu. Press
Press
to display the Setup Menu. The Setup Menu lists the setup
selections on your meter.
PhaseOrder
PT Secondary
CT Primary
CT Secondary
Vb Polarity
Vc Polarity
Ib Polarity
Ic Polarity
I4 Polarity
Nominal
Nominal
Current
Frequency
Stored IPv4
Stored IPv4
MAC Address
Subnet Mask
Gateway
Baud Rate
RX Timeout
Unit ID
Baud Rate
RX Timeout
Unit ID
Measurement
PF
Symbols
Convention
Voltage
Current
Power
Resolution
Resolution
Resolution
Timezone
Date Format
DST Off set
Off set
Time Sync
Time Sync
Source
Type
until Setup Menu is highlighted.
Display
I4 Primary
I4 Secondary
Serial Port
RS485 Bias
Serial Port
RS485 Bias
7EN05-0390-00
- Quick Links:
- 9810 Series
- Installation
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
