Hopping Foot - Brother Dream Quilter 15 Instruction Manual

Hide thumbs Also See for Dream Quilter 15:

Table of Contents

Parts Needed:

3mm Allen Wrench

1. Using the hand wheel on the back of your machine, rotate your machine until the needle bar is in

the lowest position.

2. Attach your hopping foot to the press bar using a M3 Thumb Screw (don't tighten during this

step)

Needle Plate

3. Place 4-8 sheets of paper (approximately 0.5mm) under the foot and lower the hopping foot

to the top of the surface. You may need to use more or less sheets of paper if your project is

particularly thick or thin.

4. Tighten the bolt using the 3mm Allen Wrench.

Note: The Hopping Foot needs to be adjusted for thicker and thinner fabrics, if the machine is

skipping stitches lower the hopping foot.

Hopping Foot Adjustment

Press Bar

M3 Thumb

Screw

Hopping Foot

3mm Allen

Wrench

M3 Thumb

Screw

Table of Contents

Show Quick Links

Table of Contents