Chassis Components - Cisco Firepower 9300 Hardware Installation Manual
Hide thumbs
Also See for Firepower 9300:
- Hardware installation manual (84 pages) ,
- Installation & maintenance (36 pages) ,
- Command reference manual (421 pages)
Table of Contents
Advertisement
Chassis Components
Feature
Power supply types
Redundant power
Fan slots
Storage
Chassis Components
The Firepower 9300 chassis contains the following components:
• Firepower 9300 Supervisor—Chassis supervisor module
• Firepower 9300 Security Module—Up to three security modules
• Firepower Network Module—Two single-wide network modules or one double-wide network module
• Two power supply modules (AC or DC)
• Four fan modules
Power Switch
Note
Note
Cisco Firepower 9300 Hardware Installation Guide
4
Description
AC, DC, and HVDC
Note
Do not mix power supply types or wattage.
Yes 1 + 1
Four (hot-swappable)
On rear panel
Up to 2.4 TB per chassis (800 GB per security module in RAID 1 configuration)
• Management port
• RJ-45 console port
• USB Type A port
• Eight ports for 1- or 10-Gigabit Ethernet SFPs (fiber and copper)
The initial Firepower 9300 AC chassis has no external power switch. You reset the Firepower 9300 using
CLI commands. To physically power cycle the 9300, you must unplug the power cord and then plug the
power cord back in.
After removing power from the chassis either by moving the power switch to OFF or unplugging the
power cord, wait at least 10 seconds before turning power back ON.
The Firepower 9300 chassis has a standby power switch at the rear of the chassis. It controls both power
supply modules. You must shut down the software applications gracefully before turning the switch to
OFF.
Overview
Hide quick links:
Advertisement
Table of Contents
