Cisco Firepower 9300 Hardware Installation Manual page 68

Hide thumbs Also See for Firepower 9300:

Table of Contents

Remove and Replace the Single-Wide Network Module

Figure 46: Firepower Network Module 10G

Step 1

Do one of the following:

a) Power down the chassis by moving the power switch to the OFF position (if removing a network module that does

not support hot swapping).

See

Chassis Components, on page 4

b) Bring the network module offline using the appropriate CLI command (if removing a network module that supports

hot swapping). All network module configuration is saved.

Cisco Firepower 9300 Hardware Installation Guide

Captive screw/handle

Ethernet X/3

Ethernet X/7

Ethernet X/4

Ethernet X/8

for more information about the power switch.

Ethernet X/1

Ethernet X/5

Ethernet X/2

Ethernet X/6

Network activity LEDs

• Off—No connection or port is not in

use.

• Amber—No link or network failure.

• Green—Link up.

• Green, flashing—Network activity.

Maintenance and Upgrade

Table of Contents

Show Quick Links

Table of Contents