Table of Contents
Advertisement
The HP 527 is a Wi-Fi Alliance authorized Wi-Fi CERTIFIED
802.11a/b/g/n/ac product. The Wi-Fi CERTIFIED Logo is a certification
mark of the Wi-Fi Alliance.
HP 527 Dual Radio 802.11ac Unified Wired-WLAN
Walljack quick start guide
This quick start guide shows you how to install and get started using the HP 527 Dual
Radio 802.1 1ac Unified Wired-WLAN Walljack (RMN BJNGA-FB0005) JH048A
(AM), JH049A (WW), JH050A (JP), JH051A(IL), JH052A (20 pack AM), JH053A (20
pack WW), hereafter referred to as the HP 527.
Hardware overview
Front view
3
4 5
2
1
1 2
Back view
1: Pass Through port
2: Uplink port
Bottom views
3: GigabitEthernet LAN ports 1 and 2
4: PoE Out GigabitEthernet LAN port 3
5: Pass Through port
1
Advertisement
Table of Contents
Related Manuals for HP 527
Summary of Contents for HP 527
-
Page 1: Hardware Overview
HP 527 Dual Radio 802.11ac Unified Wired-WLAN Walljack quick start guide This quick start guide shows you how to install and get started using the HP 527 Dual Radio 802.1 1ac Unified Wired-WLAN Walljack (RMN BJNGA-FB0005) JH048A (AM), JH049A (WW), JH050A (JP), JH051A(IL), JH052A (20 pack AM), JH053A (20 pack WW), hereafter referred to as the HP 527. -
Page 2: Package Contents
2x2 MIMO with two spatial streams at a rate of up to 850 Mbps. Reset button The reset button is accessible through a hole on the side panel of the HP 527. To reset the HP 527, insert a paper clip into the reset button hole, and press and quickly release the button. - Page 3 Power Uplink Radio LAN (1 to 3) Description The AP has no power. Power applied. If the power LED remains orange Steady orange after several minutes, the AP failed to load the software. Green, flashing every 2 seconds The AP is starting up. (0.5Hz) The AP is looking for an IP Green, flashing...
- Page 4 Before you connect power to the AP, verify that the power supply is steady. The HP 527 supports an 802.3af PoE PSE connection to one device on LAN port 3. This feature is dependent on the power source of the HP 527, as follows: Supports 802.3af class 1/2/3 PoE Out when the 803.3at (PoE+) power supply...
-
Page 5: Installation
To avoid possible bodily injury or equipment damage, read the following safety recommendations before you install an HP 527. The recommendations do not cover every possible hazardous condition. Install with six inches or more of clearance around the walljack. Keep the chassis clean and dust-free. - Page 6 Figure 1 Securing the mounting bracket to an electrical outlet box (EU) M3.5 × 25 Figure 2 Securing the mounting bracket to an electrical outlet box (US) M3.5 × 25...
- Page 7 Connect the network cable from the box to the RJ-45 Uplink port on the back of the HP 527. If required, also connect the cable providing support for pass- through devices to the Pass Through port on the back of the HP 527. Figure 3 Connecting the network cable...
- Page 8 Align the installation hole in the rear of the AP with the standout on the mounting bracket. Figure 4 Aligning the installation hole...
- Page 9 Push the HP 527 onto the mounting bracket, and then slide it down until it is fully engaged. Then secure the AP to the bracket by using the Phillips-head screw or the security-head security Torx-10 screw. Do not let go of the HP 527 until you confirm that it is securely in place.
-
Page 10: Technical Support
Provided access services After the installation is complete, connect equipment to the HP 527 as follows: Printer Laptop Pass Through PoE Switch IP TV Phone IP Phone Technical support For worldwide technical support information, see the HP support website at www.hp.com/networking/support... -
Page 11: Industry Canada Notice
Referring to the multi-transmitter policy, multiple-transmitter(s) and module(s) can be operated simultaneously without C2P. This device will not permit operation on channels 120- 1 28 for 802.1 1a, 802.1 1n, and 802.1 1ac modes that overlap the 5600-5650 MHz band. A 20 cm minimum distance must be maintained between the antenna and the users for the host this module is integrated into. -
Page 12: Notice For Korea
Notice for Korea Class B (broadcasting This device obtained EMC registration mainly communication device for home for home use (Class B) and may be used in all use) areas. Notice for Taiwan... - Page 13 Eurasian Economic Commission HP 527 Dual Radio 802.11ac Unified Wired-WLAN Walljack (JH049A) +3 527 6LQJOH 5DGLR Q 8QLILHG Wired WLAN Walljack (JH049A) HP 527 6LQJOH 5DGLR Q :/$1 JH049A) · +3 527 802.11n :/$1 JH049A) (RMN BJNGA-FB0003) Manufacturer...
-
Page 14: Product Overview
5 50, +7 (727) 355 35 51 Product overview The HP 527 Access Point supports IEEE 802.1 1a/b/g/n/ac. It has two internal antennas supporting 2x2 MIMO with two spatial streams at a rate of up to 850 Mbps. -
Page 15: Manufacturing Date
Manufacturing date The manufacturing date is defined by the serial number. CCYMBBBZZZ (HP serial number format for this product) Valid date formats include: Y (Y) = Year of Manufacture (Where Y indicates the year counting from within each new decade, with 2000 as the starting point. For example, 2 for 2002. -
Page 16: Environmental Conditions
CCY Y MBBBZZZ Y (Y) = 2000 2002 2010 201 1 . . . 2000 , YY – 2012 M (M) = M, 1- - CCYMBBBZZZ Y (Y) — 0 — 2010, 1 — YY - ... - Page 17 Altitude: Up to 13,123 ft (4 km) 1 15°F 45°C) +158°F +70°C) 0°C – 45°C (32°F – 1 15°F) 5% - -40°C +70°C (-40°F +158°F) 5% - (13 123 1 15 – +70 °C –...
-
Page 18: Electrical Characteristic
Specifications Physical characteristics Dimensions: 150 × 86 × 35 mm (5.9× 3.39 × 1.38 Weight: 0.24 kg (8.47 oz) Mounting position: Standard US or EU electrical box Electrical characteristic IEEE 802.3af and 802.3at PoE compliant for Gigabit Ethernet Input : 100 VAC to 240 VAC, Output :+48 V @ 0.63 A... - Page 19 Memory and processor Atheros AR9557 Storage media Nor Flash 4MB, Nand Flash 128MB Memory DDR2 256 Performance Radios 802.1 1 a/b/g/n/ac Radio operation modes Client access, Local mesh, Packet capture AP operation modes Managed Wi-Fi Alliance Certification a/b/g/n/ac Wi-Fi Certified...
- Page 20 ·...
- Page 21 Disposal of Waste Equipment by Users in Private Households This symbol means do not dispose of your product with your other household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment.
- Page 22 ·...
- Page 23 © Copyright 2014 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. May 2014 Printed in China Document part #...