Table of Contents
Advertisement
7.2 DIAGNOSIS
7.2.1 DISASSEMBLY
-
Removing the Case(not shown)
1. Remove the nine screws.
2. Remove the Case.
-
Removing the Panel Unit(not shown)
1. Remove the six screws.
2. Remove the two Panel Units.
-
Removing the Amp Unit(Fig.1)
Remove the nine screws.
Use 2 pcs. of screw and insert them into the
two holes marked with an arrow. Alternately
tighten them little by little until the Sub Heat
Sink separates from the Heat Sink.
Sub Heat Sink
Heat Sink
Amp Unit
Sub Heat Sink
Fig.1
GM-232
15
Advertisement
Table of Contents
