Table of Contents
Advertisement
SFP Guidelines
SFP Guidelines
The Supervisor Engine 6L-E has two X2 ports that can support Cisco TwinGig modules providing two
SFP connections to other network devices. You can have a total of four SFPs.
For installation information, refer to the
Use only Cisco SFP modules on your Cisco device. Each SFP module has an internal serial EEPROM
that is encoded with security information. This encoding provides a way for Cisco to identify and
validate that the SFP module meets the requirements for the device.
For supported SFP transceiver media types, refer to:
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_
6982.html
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL6
32702.html
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_
6981.html
Fiber-Optic Connectors
Fiber-optic cable connectors can be damaged by improper cleaning and connection procedures. Dirty or
damaged fiber-optic connectors can result in communication that is not repeatable or inaccurate.
Fiber-optic connectors differ from electrical or microwave connectors. In a fiber-optic system, light is
transmitted through an extremely small fiber core. Because fiber cores are often 62.5 microns or less in
diameter, and dust particles range from a tenth of a micron to several microns in diameter, dust and any
contamination at the end of the fiber core can degrade the performance of the connector interface where
the two cores meet. Therefore, the connector must be precisely aligned, and the connector interface must
be absolutely free of trapped foreign material.
Connector loss, or insertion loss, is a critical performance characteristic of a fiber-optic connector.
Return loss is also an important factor. Return loss specifies the amount of reflected light; the lower the
reflection, the better the connection. The best physical contact connectors have return losses greater than
-40 dB, although -20 to -30 dB is more common.
The connection quality depends on two factors: the type of connector and the proper cleaning and
connection techniques. Dirty fiber connectors are a common source of light loss. Keep the connectors
clean at all times, and keep the dust covers installed when the connectors are not in use.
Before installing any type of cable or connector, use a lint-free alcohol pad from a cleaning kit to clean
the ferrule, the protective white tube around the fiber, and the end-face surface of the fiber.
As a general rule, whenever there is a significant, unexplained loss of light, clean the connectors.
Caution
Use extreme care when removing or installing connectors so that you do not damage the connector
housing or scratch the end-face surface of the fiber. Always install protective covers on unused or
disconnected components to prevent contamination. Always clean fiber connectors before installing
them.
To clean the optical connectors, use a CLETOP cassette cleaner (type A for SC connectors or type B for
MT-RJ connectors) and follow the product directions. If a CLETOP cassette cleaner is not available,
follow these steps:
Installation and Configuration Note for the Cisco Catalyst 4500 E-Series Supervisor Engine 6L-E
26
Cisco SFP and SFP+ Transceiver Module Installation
Notes.
OL-19334-02
Hide quick links:
Advertisement
Table of Contents
