Attaching Module Interface Cables
Figure 10
engine.
Figure 10
Pin 1
Pin 8
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Always keep caps and plugs on the fiber-optic connectors on the cable and the switch when they are not
Note
in use.
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
SC Connector
The SC connector, shown in
the external SMF or MMF network.
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Make sure that the optical connectors are clean before making the connections. Contaminated connectors
Note
can damage the fiber and cause data errors.
Always insert the network connector completely into the socket. A secure connection is especially
important when you are establishing a connection between a module and a long distance (1.24 miles)
(2 km) network or a module and a suspected highly attenuated network. If the link LED does not light,
try removing the network cable plug and reinserting it firmly into the module socket. It is possible that
dirt or skin oils have accumulated on the plug faceplate (around the optical-fiber openings), generating
significant attenuation and reducing the optical power levels below threshold levels so that a link cannot
be made.
OL-19334-02
and
Figure 11
show the connector types used to attach interface cables to the supervisor
RJ-45 Connector
Figure
11, is used to connect fiber-optic module ports or transceivers with
Installation and Configuration Note for the Cisco Catalyst 4500 E-Series Supervisor Engine 6L-E
RJ-45 (both ends)
Attaching Module Interface Cables
23