Table of Contents
Advertisement
1
M o n o g r a m m i n g
and Embroidering, Using Embroidery Hoop
PATTERN DIAL
STITCH LENGTH
STITCH WIDTH
PRESSER FOOT
NEEDLE
OTHERS
:
1
:
Set
a t
any position
: 0-5
:
Removed
: Single
: Darning plate
PREPARATION
FOR
MONOGRAMMING
AND
EMBROIDERING
1. Place darning plate on needle plate.
2. Set your sewing machine a s per above instructions.
3. Draw lettering (for monogramming) or design (for
embroidering) on the right side of the material.
4. Stretch work between embroidery hoops a s firmly
a s possible.
5. Place the work under the needle and lower presser
bar.
6.
Pull lower thread up through the work as starting
position by turning balance wheel and make a few
holding stitches.
7.
Hold the hoop with thumb and forefingers of both
hands while pressing the material with middle and
third fingers and supporting the outside of hoop
with smaller finger.
MONOGRAMMING
1.
Sew, moving hoop slowly along the
lettering at an even rate of speed.
2. Secure with a few straight stitches.
(NOTE:
These instructions also apply to
embroidering)
EMBROIDERING
1. Stitch outline of design by moving
embroidery hoop accordingly.
2. Fill in design stitch from outline of
design to inside and from inside to edge
of outline alternately until1 design is
completely
filled
in.
Keep stitching
close together.
NOTE: A long stitch i s made by moving
embroidery hoop rapidly and a
short stitch
i s
made by moving
it
slowly.
I
I
- Quick Links:
- Machine
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
