hit counter script
Cisco ASA5506-AP702 User Manual
  1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Control Unit
  5. ASA5506-AP702
  6. User manual

Cisco ASA5506-AP702 User Manual

Kenton wlan module
Hide thumbs
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Kenton WLAN module
User Guide
Model name: ASA5506-AP702
1

Advertisement

Table of Contents
loading

Related Manuals for Cisco ASA5506-AP702

Summary of Contents for Cisco ASA5506-AP702

  • Page 1 Kenton WLAN module User Guide Model name: ASA5506-AP702...

  • Page 2: Functional Overview

    1 Purpose The purpose of this document is to give an overall description of the hardware requirements of the WLAN module used in Kenton project. 1.1 Scope This document contains the requirements for the subject system and its top-level or architectural design for an ODM partner.
  • Page 3 (using the Cisco Logo as shown in EDCS-775872. The minimum width of the Cisco logo is ½”. The location is preferable on the top of the PCB, but the back is acceptable if spacing doesn’t allow it to be on the top. It cannot be underneath a soldered component (but can be underneath a mini-PCI card if one exists).

  • Page 4: Fcc Statement

    FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

  • Page 5: Important Note

    IMPORTANT NOTE: This module is intended for OEM integrator. The OEM integrator is responsible for the compliance to all the rules that apply to the product into which this certified RF module is integrated. Additional testing and certification may be necessary when multiple modules are used. 20cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is integrated into.
  • Page 6 IC Statement This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
  • Page 7 The maximum antenna gain permitted (for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to comply with the e.i.r.p. limit. le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5250-5350 MHz et 5470-5725 MHz doit se conformer à la limite de p.i.r.e.; Users should also be advised that high-power radars are allocated as primary users (i.e.
  • Page 8 Le présent émetteur radio (ASA5506-AP702) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
  • Page 9 Telec Statement: 5GHz product for indoor use only. CE Statement: This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Table of Contents