Cisco Nexus 9372PX Hardware Installation Manual page 27

Nx-os-mode switches

Table of Contents

Installing the Switch Chassis

b) Position a slider rail at the desired level on the back side of the rack and use two 12-24 screws or two 10-32 screws,

depending on the rack thread type, to attach the rails to the rack (see the following figure). Tighten 12-24 screws to

30 in-lb (3.39 N·m) of torque and tighten 10-32 screws to 20 in-lb (2.26 N·m) of torque.

Figure 5: Installing the Slider Rails

Slider rail with screw holes aligned to screw holes in

rack

c) Repeat Step 3 to attach the other slider rail to the other side of the rack.

To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count

the screw holes in the vertical mounting rails.

Step 4

Insert the switch into the rack and attach it as follows:

Cisco Nexus 9372PX and 9372PX-E NX-OS-Mode Switches Hardware Installation Guide

Two customer-supplied 12-24 or 10-32 screws used

to attach each slider rail to the rack

Installing the Switch

Table of Contents

Show Quick Links

Table of Contents

Nexus 9372px-e