Page 1
Besorgen Sie sich daher bitte im Handel erhältliche Schrauben. • Los tornillos de montaje de ménsula en la pared no vienen con el producto, compre los tornillos por separado en la tienda. AN-65AG1 取扱説明書 OPERATION MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG MANUAL DE MANEJO 適応機種...
• Thank you for purchasing a SHARP product. Before using the product, please be sure to read this operation manual carefully. In particular, be sure to read the section “To Ensure Safe and Correct Use.” After reading the manual, keep it in a convenient location where it can be accessed at any time.
Special skill is required to install the LCD color TV, so please have it installed by a contractor specializing in such installation. The customer should not attempt to install the TV. Sharp shall not be responsible for improper installation or any accidents, damage, or injury resulting from improper installation.
Page 4
Determine the TV installation location after taking into consideration the viewing posture, line of sight, and the visual and aural ranges. • Sharp shall bear no responsibility for damages, etc., caused by the LCD color TV falling due Caution to insufficient installation strength or improper installation.
Wall-Mount Bracket Installation Determine the location where the base bracket will be installed. (1) Use tape or other means to mark the measured positions on the wall where the display will be installed. The center of the “X” drawn from the four corners of the square marks the center of the panel.
Installing the wall-mount bracket • Be sure to use at least two people to perform the wall-mount bracket installation work for the LCD color TV. Caution • The installation work must be conducted while the LCD color TV is standing upright, so be careful that it does not fall over.
Page 7
Installing the wall-mount bracket (Continued) Connect the system cables and power cord to the terminals on the back of the LCD color TV. System cables Use the cable holder at the center of the back of the LCD color TV and the cable holders holding the speaker cables to connect the system cables.
Page 8
Set the angle of the wall-mount bracket • Please perform this work before mounting the LCD color TV on the wall. Caution • When setting the angle of the wall-mount bracket, be careful not to pinch your fingers, etc. Remove the perpendicular positioning screws from the wall-mount bracket (2 screws each on the left and right sides).
Page 9
Remove the stands • Be sure to use at least 3 people for the work from this point onward. Caution • Be very careful when holding the LCD color TV at a slant or when lifting it up. Lift up the LCD color TV and remove the stand. While the stand is being held down, lift up the LCD color TV to remove it from the stand.
Page 10
Installing the LCD color TV on the wall • Be sure to use at least 4 people when installing the LCD color TV to the base bracket. Caution • Be sure to perform Steps 1 and 2 below. Only performing Step 1 could result in the display falling and injuring someone.
Page 11
Printed on 100% post-consumer recycled paper. Imprimé sur 100% de papier recyclé. Printed in Japan Imprimé au Japon DSC1 TINSE1082MPZZ (1)